Oil Cooler Res 18 Ec / Res 16 Tec - SDMO RES 9.5EC Manual De Instalación, Uso Y Mantenimiento

2. Replace the oil filter.
a. Clean the area around the oil filter. Remove the oil filter by turning it anticlockwise using an oil filter wrench.
b. Clean the mating face of the adaptor in contact with the oil filter.
c. Apply a thin coat of fresh engine oil to the rubber seal on the new oil filter.
d. Fit the new oil filter according to its instructions.
Note: dispose of all waste (engine oil, fuel, filters, etc.) in line with environmental protection guidelines.
3. Fill up with oil.
a. Remove the oil filler plug and fill with engine oil to the "F" mark on the dipstick. The engine oil capacity is 2.8 L.
b. Put the dipstick and the oil filler cap back in place.
c. Check that the generating set's main switch is set to "OFF".
d. Reconnect the generating set engine starter battery, negative (-) lead last.
e. Switch back on the electrical power supply to the battery charger.
f. Start the generating set and allow it to run for one minute to enable the oil to reach its operating pressure.
g. Switch off the generating set, wait for 1 minute, then check the oil level again. Top up the oil to the "F" mark on the
dipstick, as required.
4. Check for leaks.
a. Check for oil leaks.
b. In the event of a leak, carry out a repair, then check the oil level again.
c. Refit the side panel on the enclosure.
d. Screw back the two retaining screws of the side panel.

4.1.4 Oil cooler RES 18 EC / RES 16 TEC

The oil cooler must be inspected and cleaned at the intervals indicated in the maintenance schedule. The oil cooler must be kept
free of debris.
See figure 4.2 for the oil cooler location. The oil cooler is located under the No. 2 cylinder shroud.
Remove the top mounting screw and loosen the two side screws, then lift off the cylinder shroud.
Clean the outside of the oil cooler fins with a brush or with compressed air
1. Oil cooler
Figure 4.2: Oil cooler location
63/73