Hold
Pump operation can be paused by pressing
HOLDING and the yellow LED indicator will be lit up to give a quick visual indication of an informational status in a darkened room.
Note: the pump's alarm will sound if it has been left HOLDING for 10 minutes without further input.
There are five options available during HOLDING. See Figures 18A and 18B
Clear Volume Fed
Press
CLEAR VOLUME to re-zero the output feed totals "mL FED," "BOLUSES FED," and "mL FLUSH."
4
Adjust Settings
Press
ADJUST SETTINGS to return to one of the opening menus shown in Figures 7A-7D, thus allowing any setting to be modified.
4
If the pump set has been removed after going into HOLD, the opening menu will show LOAD A SET, as seen in Figures 5A-5B
RESUME IN __ MIN
Press "RESUME IN __ MIN" once to immediately place the Kangaroo™ ePump™ into a 30-minute resume running mode. Pressing
the RESUME IN __ MIN button again will cycle the "resume in" time back to zero. No other input is needed to start the countdown,
as the time immediately counts down after the 30 minute value is reached.
Run Mode
Press
RUN to immediately restart pump operation. This option will not be available if the pump set is removed during HOLD.
4
View History
(Not Available in EZMODE)
Press
HISTORY to access the HISTORY screen. Use this screen to review feeding and flushing history. See subsection "More
4
Options" below for further information.
Kangaroo™ ePump™ Enteral Feed and Flush Pump with Pole Clamp
HOLD while it is RUNNING, such as in Figure 15A. The status line will indicate
4
Figure 18A. HOLDING mode options,
continuous feeding mode.
(Not Available in EZMODE)
.
Figure 18B. HOLDING mode options,
intermittent feeding mode.
18
.
Table of Contents