Biotech Menu; Accessing The Biotech Screen; Biotech Screen Data; Biotech Options - Coviden Kangaroo ePump Manual De Instrucciones

Bomba para irrigación y alimentación enteral con abrazadera para palo de gotero, programable
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 197

BioTech Menu

The BioTech screen will show technical information about the pump, and has a lock feature to lock the pump settings against
unauthorized changes.

Accessing the BioTech Screen

To get the BioTech screen, press the power button to start the pump, and press and hold the top
sequence (Kangaroo icon "hops" across the screen) executes. You must be pressing the top
order to access the BioTech menu. Figure 21 shows the BioTech screen.
Figure 21. BioTech screen.
Figure 22. BioTech option screen,
with Lock Setting, EZMODE, and
Communications features activated.

EZMODE

Press
EZMODE to activate the EZMODE feeding option. A check mark will appear next to the
4
that the feature is active. Pressing the
the EZMODE feature is turned on, the EZMODE icon will appear in the lower right corner of the LCD next to the battery icon (see
Figure 9). See page 12 for EZMODE details.
Figure 23.
Kangaroo™ ePump™ Enteral Feed and Flush Pump with Pole Clamp

BioTech Screen Data

SN is the serial number of the pump.
SW shows the software version number in this pump.
FLASH shows the version number of the flash data installed in this pump.
CERT INTV indicates the number of times the pump has been powered on since certification.

BioTech Options

Lock Settings Feature — Program Locked
To "lock" the settings against unauthorized changes, press
mark, as shown in Figure 22. The settings can only be changed again by pressing
SETTINGS to remove the check mark. If the settings are locked and a change is attempted, the
screen will indicate PROGRAM LOCKED, and will not allow access to the parameters, Figure 16.
The pump can be PRIMED or set to RUN, HOLD, etc. when settings are locked.
EZMODE button again will remove the check mark indicating that the feature is off. If
4

COMMUNICATION

Press
COMMUNICATION to activate the communication feature. A check mark will
4
appear next to the
4
COMMUNICATION button again will remove the check mark indicating that
Pressing the
4
the feature is off. If the COMMUNICATION feature is turned on, the COMMUNICATION icon
will appear in the lower right corner of the LCD next to the battery icon (see Figure 23).
Turning the COMMUNICATION feature on will initiate data transfer of various
pump settings, status, errors, etc. through the serial I/O port. If feature is
desired, please contact technical support for additional information.
Communication icon
4
COMMUNICATION button to indicate that the feature is active.
20
button while the startup
4
button at the end of the sequence in
LOCK SETTINGS to get the check
4
LOCK
4
EZMODE button to indicate
4
Table of Contents

Publicidad

Tabla de contenido
loading

Tabla de contenido