Error Messages - Diemer P1800 RIDICON Manual

Invalid time is displayed
and the time cannot be
adjusted.
History records cannot
be exported.
The displayed syringe
size is incorrect.
The syringe calibration
cannot be performed.
Displayed pressure level
is obviously disagrees
with reality.

7.2 Error messages

Information:
 Error messages including the fault and alarm information caused in power-on
and run-time self-test, these all messages displayed in the form of text and ICONS
on the screen.
Message displayed
EEPROM
Battery loose
Syringe calibration
error
Pressure sensor
error
Main board is defective.
Button cell is exhausted.
Main board is defective.
RS232 circuit on main board is
defective.
RS232 connection
disconnected.
Syringe size detection board is badly
connected.
Syringe size detection board is not
installed properly or is defective.
Main board is defective.
Potentiometer connected to J6 on main
board is disconnected or defective.
Main board is defective.
Force sensor connection wires are
disconnected.
Force sensor is defective.
Main board is defective.
Description
 EEPROM chip or mainboard
failure
 No battery in machine
 Battery failure
 Battery connection wires are
shorted.
 The EEPROM
calibration syringes dates are
failure
 Incorrect voltage presents at
point TP7 on main board
when syringe is not installed
or main board is defective
Replace main board.
Replace button cell.
Replace main board.
Replace main board.
wires are Reconnect RS232 port to main
board.
Reconnect
related wires or connectors.
Reinstall or replace syringe
size detection board.
Replace main board.
Reconnect
potentiometer.
Replace main board.
Reconnect force sensor.
Replace force sensor.
Replace main board.
Recommended actions
 Replace
mainboard
 Install battery on mainboard
 Replace battery
storage
 Calibration the syringe again
 If main board or pressure sensor is
replaced, adjust potentiometer PJ1
and make the voltage at TP7 on
main board within range of
or replace the
or replace
EEPROM chip or
106