Diemer P1800 RIDICON Manual página 114

Immunity IEC 60601
test test level
Conducted 3 Vrms
RF
150 kHz to
IEC 80 MHz
61000-4-6 Outside ISM
bands a
10 Vrms
150 kHz to
80 MHz
In
Radiated RF bands a
IEC 10 V/m
61000-4-3
80 MHz to
2.5 GHz
NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic is affected by absorption and
reflection from structures, objects and people.
a The ISM (industrial, scientific and medical) bands between 150 kHz and 80 MHz are 6.765 MHz to 6.795
MHz; 13.553 MHz to 13.567 MHz; 26.957 MHz to 27.283 MHz; and 40.66 MHz to 40.70 MHz
b The compliance levels in the ISM frequency bands between 150 kHz and 80 MHz and in the frequency
range 80 MHz to 2.5 GHz are intended to decrease the likelihood that mobile/portable communications
equipment could cause interference if it is inadvertently brought into patient areas. For this reason, an
additional factor of 10/3 is used in calculating the recommended separation distance for transmitters in these
frequency ranges.
c Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and
Compliance
Electromagnetic environment - guidance
level
Portable and mobile RF communications equipment should be
used no closer to any part of the Syringe Pump, including
cables, than the recommended separation distance calculated
from the equation applicable to the frequency of the
transmitter.
3V （ V
） Recommended separation distance
1
d  [
d  [
10V （ V
）
2
d  [
d
10 V/m （ E
）
1
where p is the maximum output power rating of the
ISM
transmitter in watts (W) according to the transmitter
manufacturer and d is the recommended separation distance
in metres (m).
Field strengths from fixed RF transmitters, as determined by
an electromagnetic site survey
compliance level in each frequency range.
Interference may occur in the vicinity of equipment marked
with the following symbol:
3.5
] P
V
1
12
] P
V
2
12
] P
80 MHz to 800 MHz
E
1
23
800 MHz to 2.5 GHz
 [
] P
E
1
b
should be less than the
c
d
116