Diemer P1800 RIDICON Manual página 105

Pressure
calibration error
KEY ERR
Rate abnomal
FLANGE
INSERTION
ERROR
PLUNGER
DISENGAGED
LOOSE
OCCLUSION
EMPTY
BATT EMPTY
 Pressure sensor
disconnected
 Pressure sensor is defective
Pressure is not calibrated or
pressure calibration error.
 Key holding during infusion /
pause alarm
 A key is stuck or was held for
over 5 seconds.
 Actual flow rate is
comply with the expected
rate.
 Potentiometer
wires are shorted.
 Motor running check the
sensor failure
 Syringe flange
board is defective
 Syringe flange
board is disconnected from
main board
 Main board is defective
 Syringe plunger
board or plunger
detection board is defective
 Plunger lock detection board
is disconnected from main
board
 Main board is defective
 Syringe loose detection board
is defective
 Syringe loose detection board
is disconnected from main
board
 Main board is defective
 Syringe or extension line is
occluded
 Pressure sensor is defective
 Syringe is empty
 Battery is exhausted
is 200±5mV when syringe is not
installed.
 Reconnect pressure sensor
 Replace pressure sensor
 Perform pressure calibration
 Check keyboard and release the
stuck key.
 Replace the keyboard
not  Calibration syringes
 Replace motor
 Re-connection
connection potentiometer
detection  Replace syringe flange detection
board
detection  Re-solder the wire connecting
syringe flange detection board
and main board
 Replace main board
detection  Replace
lock detection board
 Replace plunger lock detection
board
 Re-solder the wire connecting
plunger lock detection board and
main board
 Replace main board
 Replace syringe loose detection
board
 Re-solder the wire connecting
syringe loose detection board and
main board
 Replace main board
 Check syringe or extension line
for sign of occlusion and take
necessary connective action
 Replace pressure sensor
 Change syringe or end the
infusion
 Connect to AC power source
or replace
syringe plunger
107