Homelite HCS3335 Manual De Utilización página 42

GB
F D E
MAINTENANCE
WARNING
Silencer surfaces are very hot during and after
operation of the chainsaw. Keep all body parts
away from the silencer. Serious burns may occur
if contact is made with the silencer.
1. Allow the silencer to cool.
2. The spark arrester screen (B) is retained by the
deflector (C). Remove the nuts (D) and screen
retainer to access the spark arrester screen.
3. Replace the spark arrester screen if it is cracked or
otherwise deteriorated.
CHAIN BRAKE (Fig. 71 & 72)
Remove the clutch cover and clean the chain brake
■
components. Check wear on the brake band (A).
If brake band is worn or deformed, have it serviced
at your nearest authorised service dealer. The
band thickness should not be less than 0.60 mm
(0.024 in.), or worn halfway through.
Always keep the chain brake mechanism clean (B)
■
and lightly lubricate the linkage (C).
Always test the chain brake performance after servicing
■
or cleaning. Refer to "Operation – Operating Chain
Brake" earlier in this manual for additional information.
Check and, if damaged, replace the chain catcher (9).
■
I P NL S DK N FIN GR HU CZ RU
English
STORING THE CHAINSAW (1 MONTH OR
LONGER)
1. Drain all fuel from tank into a container approved for
petrol.
2. Run the engine until it stops. This will remove all
fuel-Lubricant mix that could become stale and leave
varnish and gum in the fuel system.
3. Drain all bar and chain Lubricant from tank into a
container approved for Lubricant.
4. Clean all foreign material from the saw.
5. Store it in a well-ventilated place that is inaccessible
to children.
NOTE: Keep away from corrosive agents such as garden
chemicals and de-icing salts.
Abide by all government and local regulations for the safe
storage and handling of petrol. Excess fuel should be used
in other 2-cycle engine powered equipment.
34
RO PL SLO HR TR EST LT LV SK BG