Dea NET724 EVO Instrucciones De Uso Y Advertencias página 30

NET724 EVO
WARNING DEA System reminds all users that the selection, positioning and
installation of all materials and devices which make up the complete
automation system, must comply with the European Directives 2006/42/CE
(Machinery Directive), 2014/53/UE (RED Directive). In order to ensure a suitable
level of safety, besides complying with local regulations, it is advisable to comply
also with the above mentioned Directives in all extra European countries.
WARNING Under no circumstances use the device in an explosive atmosphere
or in areas that may be corrosive or could damage product parts. Check that
the temperatures at the installation site are suitable and comply with the
temperatures declared on the product label.
WARNING When working with the "dead man" switch, make sure that there
are no people in the area where the automation is being used.
WARNING Check that there is a switch or an omni polar magneto-thermal
circuit breaker that enables complete disconnection in case of over voltage
category III conditions installed upstream from the power system.
WARNING To ensure an appropriate level of electrical safety always keep
the 230V power supply cables apart (minimum 4mm in the open or 1 mm
through insulation) from low voltage cables (motors power supply, controls,
electric locks, aerial and auxiliary circuits power supply), and fasten the latter
with appropriate clamps near the terminal boards.
WARNING If the power cable is damaged, it must be replaced by the
manufacturer or its technical assistance service or, in any case, by a person
with similar qualifi cations to prevent any risk.
WARNING All installation, maintenance, cleaning or repair operations on
any part of the system must be performed exclusively by qualifi ed personnel
with the power supply disconnected working in strict compliance with the
electrical standards and regulations in force in the nation of installation.
Cleaning and maintenance destined to be performed by the user must not be
performed by unsupervised children.
WARNING Using spare parts not indicated by DEA System and/or incorrect
re-assembly can create risk to people, animals and property and also damage
the product. For this reason, always use only the parts indicated by DEA System
and scrupulously follow all assembly instructions.
WARNING After adjustment, compliance with regulatory limits values should
be detected with a force impact measuring instrument. The sensitivity of the
obstacle detection may be adjusted gradually to the door (see programming
instructions). The anti-crushing device operation must be checked after each
manual adjustment. Manual modifi cation of the force can only be done by
qualifi ed personnel by performing the measurement test according to EN 12445.
Modifi cations to the force adjustment must be documented in the machine
manual.
WARNING The compliance of the internal obstacle detection to requirements
of EN12453 is guaranteed only if used in conjunction with motors fi tted with
encoders.
28