Electrical Connections - Dea NET724 EVO Instrucciones De Uso Y Advertencias

NET724 EVO

4 ELECTRICAL CONNECTIONS

! Risk of injury and material damages due to electric shock !
! Risk of malfunction due to improper installation !
Make the connections by following the indications of the wiring diagram.
WARNING To ensure adequate electrical safety, keep the 230 V power supply cable well apart (minimum 4 mm in the air or
1 mm through insulation) from extra-low voltage cables (power supply for the motors, control units, electric lock, antenna,
auxiliary power supplies), by fastening them with adequate cable clamps near the terminal blocks.
WARNING Connect to the 230 - 240V (50/60 Hz) network using an omnipolar switch or other device guaranteeing the
network's omnipolar disengagement, with a contact opening gap = 3 mm.
1 Input IN1
2 Input IN2
3 Input IN3
4 Input IN4
5 Inputs common
6 -
7 B
M1 motor encoder output
8 A
9 +
10 +
Stabilized 24V
11 -
12 +
24V
13 -
14 +
OUTPUT 1 confi gurable 24V
15 -
16 +
OUTPUT 2 confi gurable 24V
17 -
18-19 M1 max 5A motor output
Radio antenna signal input
ANT
Radio antenna earth input
C 1 Motor earth terminal
C 2 Input for 25V ~ power supply from transformer
C 3 Output for courtesy LED light module connector
S NET-NODE 2.0 - 485/3-EXP module connector input
U 3 NET-NODE - NET-EXP plug-in module connector
30
Connection to the terminal blocks
power supply output for tested safety devices
power supply output for auxiliary devices (e.g. BAT_ADV accessory)
max 5W (see Io.31 pag. 46 for the selectable values)
max 5W (see Io.32 pag. 46 for the selectable values)
(24V_ST + 24V_AUX)
=
max 200mA