Panasonic EYADA Serie Manual De Instrucciones página 10

PREPARATION BEFORE USE
Attaching Bit
ATTENTION
⿟ When attaching or removing a bit, set
the forward/reverse lever to the " ○
(Trigger switch locked)" position, and
turn OFF the power switch of the
power adapter.
P. 17, 20
Pull the bit holder.
Insert a bit.
Insert it with the bit holder pulled.
Release the bit holder.
Check that the bit does not come
off, by pulling it lightly.
18
EN
(cont.)
■ Bits That Can Be Attached to This
Unit
6.35 mm
A B
Ball groove section*
centre
* Straight bits without a ball groove
section cannot be used.
Length of A
12 mm to 17.5 mm
(Double-ended bit)
Length of B
9 mm to 13 mm
(Single-ended bit)
Removing Bit
ATTENTION
⿟ Immediately after work, do not touch
a bit or other pointed tools, or screws.
They are hot and may cause burns.
Pull the bit holder.
Remove the bit.
Pull it out with the bit holder pulled.
Attaching Grip Attachment
The grip attachment can be attached to
all models.
(Supplied for EYADA407WA·WB only)
It can absorb the reactive force during
clutch activation, which helps reduce
fatigue.
Use in lever start mode
Align grooves in the grip
attachment with ribs on the grip.
④
③
① ⑥
②
Use in push start mode
Align grooves in the grip
attachment with ribs on the grip.
③
⑥
①
④
②
Components of the attachment
① Grip attachment (A) × 1
② Grip attachment (B) × 1
③ Trigger × 1
④ Joint × 1
⑤ Screw × 7
⑥ Spring × 1
ATTENTION
⿟ When attaching or removing the grip
attachment, set the forward/reverse
lever to the " ○ (Trigger switch
locked)" position, and turn OFF the
⑤
power switch of the power adapter.
P. 17, 20
⿟ Remove the bit before attaching or
removing the grip attachment.
⿟ After fixing the grip attachment with
screws, check for any loose screws,
backlash, or misalignment.
Align grooves in the grip
attachment (A) with ribs on
the tool grip.
Attach the trigger and the
joint to the positions shown
in the figure.
Align grooves in the grip
attachment (B) with ribs on
⑤
the tool grip.
Fasten the screws.
Check for any loose screws,
backlash, or misalignment.
Screwdriver hanger mounting hole (x 2)
19
EN