Panasonic EYADA Serie Manual De Instrucciones página 9

GUIDE TO SETUP PROCEDURES
Checking the operation
P. 17 to 27
1
After purchasing the unit, check the operation in the "Stand Alone Mode"
as described in pages 17 (PREPARATION BEFORE USE) to 27 (HOW
TO USE) before connecting it to the controller.
Pairing the tool
P. 28 to 30
2
After checking the operation, pair the tool by following the Operating
Instructions of the controller and make basic settings about the controller
to enable use in the "Wireless Communication Mode".
* The mode can be switched between the "Stand Alone Mode" and
"Wireless Communication Mode" depending on the work site.
Setting via a web browser
P. 31 to 49
3
Information about parameters and history data specific to this tool is
described in these Operating Instructions since the controller supports
other types of tools as well.
Refer to these instructions together with the Operating Instructions of the
controller when making settings.
Setting on the tool
P. 50 to 55
4
Some functions can be set on this tool while many functions are usually
set on the controller.
Make settings on this tool if necessary.
16
EN
PREPARATION BEFORE USE
Using Forward/Reverse Lever
With the forward/reverse lever, you can
change the rotation direction of the
Electric Screwdriver or lock the start.
Trigger
switch Rotation direction
position
R Reverse (Anticlockwise)
○
Trigger switch locked
F Forward (Clockwise)
R position
○ position
F position
Trigger switch lock
When you switch the forward/reverse
lever to the " ○ " position, the start of
the Electric Screwdriver is locked and
it does not rotate.
When attaching accessories or a bit,
or when not working, switch the
forward/reverse lever to the " ○ "
position to lock the trigger switch.
NOTE
⿟ If the forward/reverse lever is
switched while the motor is in action,
the motor is forcibly stopped to
rotate.
Attaching Screwdriver Hanger
Pull the screwdriver hanger
lightly on both sides.
Pulling the screwdriver hanger hard
may prevent it from returning to its
original position.
Perform attachment and removal
with necessary force.
Put it into the screwdriver
hanger mounting hole.
Screwdriver hanger mounting hole
Screwdriver hanger
mounting hole
Pull the screwdriver hanger
lightly on both sides.
Attach the screwdriver hanger and the
tool balancer as shown in the figure.
Tool balancer
Hook
Screwdriver
hanger
Hang the screwdriver hanger
on a hook of the tool balancer.
17
EN