Panasonic EYADA Serie Manual De Instrucciones página 30

PRECAUTIONS FOR WIRELESS COMMUNICATION
Cautions for using a WLAN device
The device uses a frequency band shared with other types of equipment including
industrial, scientific, and medical devices (e.g., a microwave) and radio stations
such as a premises radio station (licenced) and low-power radio station (unlicenced)
for mobile identification used in factory manufacturing lines and an amateur radio
station (licenced).
1. Before using the device, confirm that there is no premises or low-power radio
station for mobile identification or no amateur radio station operating in the
vicinity.
2. If the device causes harmful interference with a premises radio station for mobile
identification, stop use of the band immediately and consult the support centre
below for the solution of the interference problem (e.g., installing a partition).
3. If the device causes harmful interference with a premises or low-power radio
station for mobile identification or an amateur radio station or such other
problems, consult the support centre.
■ There may be noise, shorter radio coverage, or malfunction occurring in
the following environmental conditions.
• There is an obstruction (e.g., a metal or reinforced concrete object) that prevents smooth
radio propagation between the wireless-enabled tool unit and the controller.
• The antennas of the controller are covered with metal.
• An operator's body is interfering with radio propagation between an operator (the
wireless-enabled tool unit) and the controller.
• There is a microwave, PC, or any other device causing noise in the vicinity.
• A cell-phone or PHS phone is used near the wireless-enabled tool unit and the controller.
58
EN
CLEANING AND STORAGE
Cleaning
■ Wiping with Soft Cloth
Disconnect the power plug from the
outlet, remove the screwdriver cord from
the tool, and then wipe it with dry soft
cloth.
Do not use wet cloth, thinner, benzine,
alcohol, or other volatile liquids.
(Cause of discolouration, deformation, or
crack)
■ Conducting Periodic Inspection
• Periodically inspect for any loose screws,
damage, or abnormal operation.
• Periodically inspect the power adapter for
any signs of damage.
Storage
■ Avoid the following conditions
during storage.
• Car cabin or other hot places
• Places exposed to direct sunlight
• Places exposed to water or dampness
• Places with a lot of foreign bodies or dust
• Places within reach of children
• Places with gasoline or other flammables
• Places with risk of fall
Updating the Firmware
Refer to "Updating the Firmware" in the
Operating Instructions of the controller
(EYARW1).
59
EN