Panasonic EYADA Serie Manual De Instrucciones página 12

HOW TO USE
(cont.)
NOTE
⿟ The lever trigger switch can be
removed as shown in the following
figure.
Lever trigger
switch fixing
screw
Lever trigger
switch
Before removing the lever trigger
switch, check that the power switch of
the power adapter is OFF.
Setting Fastening Torque
According to the work, the clutch torque
can be adjusted in 96 steps.
■ Setting Procedure
Remove the clutch cover.
Turn the clutch cover anticlockwise.
Securing ring
22
EN
Adjust the torque with the
clutch handle.
① ②
① To increase the output torque, turn
the clutch handle clockwise.
② To decrease the output torque, turn
the clutch handle anticlockwise.
To ensure long and safe use
without causing any failure,
observe the following:
• Set the torque according to the
recommended fastening torque
chart.
P. 23
• Do not use the tool in such a manner
that causes the motor to lock.
Attach the clutch cover.
Turn the clutch cover clockwise.
Securing ring
ATTENTION
⿟ Attach the clutch cover during use so
as to prevent the clutch setting from
being changed unintentionally.
⿟ Fasten the securing ring if it is loose.
Recommended Fastening Torque Chart (Reference Values)
These data are reference values measured under the following measurement
conditions.
In actual work, they vary depending on the surrounding conditions (such as
screws, materials, and fixing methods).
5.0
4.5
4.0
3.5
3.0
2.5
EYADA212WA ・ WB
2.0
1.5
1.0
0.5
0.0
1 2 3
0
12 steps (12 clicks) per
Aligned with
gradation [0]
Slightly 96 steps (96 clicks) per
lower eight units on the scale
Measurement conditions Based on our specified measurement conditions.
* In actual work, they vary depending on the surrounding conditions (such as screws,
materials, and fixing methods). You are recommended to make a prior confirmation
in actual work.
EYADA407WA ・ WB
EYADA218WA ・ WB
4 5 6 7
one unit on the scale
Aligned with
gradation [8]
8
Scale
Slightly
higher
23
EN