Panasonic EYADA Serie Manual De Instrucciones página 15

PAIRING WITH THE CONTROLLER
Enabling Pairing
Use the Paring key on the controller unit (EYARW1).
Select the communication lamp of the number with no registration (lamp off) and hold
the Pairing key down to enter the pairing mode.
During 2 minutes of the pairing mode, start the pairing mode on a tool within the
coverage to automatically establish pairing.
If pairing is not established within the time, the pairing mode will end.
* After you attempt to start pairing, it may take some time until the controller enters the
pairing mode.
Communication lamp
Pairing key
(To register Tool No. 4)
Press the Paring key on the controller 4 times to select Tool No. 4.
Communication lamp No. 4 blinks.
No registration
(off)
While No. 4 is selected, hold down the Paring key on the
controller to enter the pairing mode of Tool No. 4.
In the pairing mode, Communication lamp No. 4 starts blinking rapidly.
Selected
(blinking)
28
EN
Selected
(blinking)
Pairing mode
(rapid blinking)
While holding down the OK button of the tool, turn ON the power
switch of the power adapter.
OK button
The tool enters the pairing mode.
Wireless communication is automatically established and paring registration is
completed, which is notified by a buzzer from the controller.
* For details, refer to the controller's Operating Instructions.
* If pairing fails, cancel pairing on the controller and then try again.
Connect the screwdriver cord to the power adapter and the tool and then
connect the power plug to the outlet before starting operation.
Communication Pairing mode
lamp (rapid blinking)
Controller
Tool (this unit)
NOTE
⿟ You can enable pairing by setting in the setting screen in addition to using the key on
the unit.
⿟ For how to enable pairing in the setting screen and details on operation of the
controller, see the Operating Instructions supplied with the controller.
⿟ There may be a lag between when the lamp switches to "registered" on the controller
and that on the tool (this unit).
Power Adapter (sold separately)
Power switch
Registered
(on)
29
EN