Panasonic EYADA Serie Manual De Instrucciones página 16

PAIRING WITH THE CONTROLLER
Cancelling Pairing
Use the Paring key on the controller unit (EYARW1).
Select the communication lamp of the tool number you want to cancel registration
(lamp on) and hold the Pairing key down to cancel pairing registration.
Communication lamp
Pairing key
(To cancel Tool No. 4)
Press the Paring key on the controller 4 times to select Tool No. 4.
Communication lamp No. 4 blinks.
Registered
(on)
While No. 4 is selected, hold down the Paring key on the
controller to cancel pairing registration of Tool No. 4.
When pairing is cancelled, Communication lamp No. 4 stops blinking and turns
off.
Selected
(blinking)
NOTE
⿟ You can cancel pairing by setting in the setting screen in addition to using the key on
the unit.
⿟ For how to cancel pairing in the setting screen and details on operation of the
controller, see the Operating Instructions supplied with the controller.
30
EN
(cont.)
Selected
(blinking)
No registration
(off)
SETTING VIA A WEB BROWSER
Displaying the Setting Screen
Displaying the Top Page.
Refer to "Displaying the Setting Screen" to "Connecting via Network" in
"PREPARATION BEFORE USE" of the Operating Instructions of the controller
(EYARW1) and make settings via a web browser to display the top page.
Displaying the Tool Screen.
① In the top page (the initial page of the setting screen), click [Settings] on the
top and select the "Connected tool" tab.
② In the "Connected tool" screen, click the desired tool number.
The screen for the tool number is displayed.
31
EN