Panasonic EYADA Serie Manual De Instrucciones página 31

ERROR CODES
Error Display on the Tool
If there is any problem, an error code blinks on the display of
the tool.
Consult the table below and take a necessary action.
• [E1] to [E9]
Pressing the OK button will clear the error display.
• [EE] and [F2] to [Fb]:
Press the OK button. Or pressing a switch will clear the error
display.
If the problem persists, stop the use immediately.
Bring it to your dealer.
Display Possible cause
An error occurred in the
tool's internal memory
or the communication
line.
The tool is hot.
The internal protective
sensor is out of order.
The tool is overloaded
or the motor is out of
order, for example.
A cord or cords are not
correctly connected.
60
EN
Action
Turn the power off and wait
approximately 10 seconds
before turning it on again.
When this does not eliminate
the problem, send the tool for
repair.
Interrupt the work and wait for
it to cool down before use.
Send the tool for repair.
Eliminate the condition(s) that
caused the overload and
recheck the condition.
When this does not eliminate
the problem, send the tool for
repair.
Check whether the cords are
correctly connected and
whether no cords are broken.
When no abnormality is found
in the cords, the power
adapter may be failed. Send
the tool for repair.
Display Possible cause
The tool circuit is failed
or out of order, for
example.
• The tool is not yet
paired with the
controller.
• The controller unpaired
the tool.
• The controller is too far
from the tool.
• There is an obstacle
between the tool and
the controller.
• The controller is
powered off.
• The installation place or
antenna direction of the
controller is
inappropriate.
An error or failure
occurred in the tool or
the controller.
Fastening parameters
are not yet set for the
tool.
Action
Send the tool for repair.
Pair the tool with the
controller.
P. 28
Check the distance between
the controller and the tool.
Check for any obstacle
around the tool and the
controller.
* Within the recommended
distance between the tool
and the controller
(approximately 16 m for
2.4 GHz and 10 m for 5 GHz)
Check if the controller is
powered on.
Check the status of the
controller's antenna.
( Refer to "Cautions for
Installation" in the Operating
Instructions of the controller.)
Turn the power off and then
on.
( When this does not eliminate
the problem, send the tool
for repair.)
On the controller, set fastening
parameters for the tool.
( Refer to "SETTING
FASTENING PARAMETERS
OF TOOLS" in the Operating
Instructions of the controller.)
61
EN