Panasonic EYADA Serie Manual De Instrucciones página 32

ERROR CODES
Display Possible cause
The fastening control
mode is not yet set.
The running mode is set
to "Repeat mode (Basic
mode)" on the controller
and a batch is not yet
registered.
The running mode is set
to "Repeat mode
(Sequence mode)" on
the controller and the
tool is in a queue.
The running mode is set
to "External control
mode" on the controller
and the tool has not
received a control input
from the external
device.
The tool's internal wiring
is broken.
A switch was operated
quickly several times.
62
EN
(cont.)
Action
On the controller, set the
fastening control mode.
( Refer to "SETTING THE
FASTENING CONTROL
MODE" in the Operating
Instructions of the controller.)
On the controller, register a
batch.
( Refer to "SETTING THE
FASTENING CONTROL
MODE" in the Operating
Instructions of the controller.)
Check the sequence setting.
( Refer to "SETTING THE
FASTENING CONTROL
MODE" in the Operating
Instructions of the controller.)
Check the I/O input on the
controller and the external
device (PLC, etc.).
( Refer to "SETTING THE
FASTENING CONTROL
MODE" in the Operating
Instructions of the controller.)
Send the tool for repair.
A switch was operated before
the reception of the signal
from the controller.
Wait a moment before
operation.
■ Error codes for errors that occur during work.
Display Possible cause
During a fastening
process, the tool was
stopped before the
clutch activated.
During a fastening
process, the rotation
time has become higher
than the upper limit or
lower than the lower
limit.
During a fastening
process, the number of
rotations has become
higher than the upper
limit or lower than the
lower limit.
During a fastening
process, the converted
torque has become
higher than the upper
limit or lower than the
lower limit.
During a fastening
process, the forward/
reverse lever was
switched.
During a fastening
process, the tool was
overloaded or the motor
failed.
Action
Nothing is wrong with the
product.
Keep the tool in action until
the clutch activates.
Nothing is wrong with the
product.
Check the workpiece and the
setting for the rotation time.
P. 36
Nothing is wrong with the
product.
Check the workpiece and the
rotation (times) setting.
P. 35
Nothing is wrong with the
product.
Check the workpiece and the
converted torque setting.
P. 33
Do not switch the forward/
reverse lever during a
fastening process.
Eliminate the condition(s) that
caused the overload and
recheck the condition.
When this does not eliminate
the problem, send the tool for
repair.
63
EN