Panasonic EYADA Serie Manual De Instrucciones página 34

ERROR CODES
NOK Error
message message
• Operation stopped to
Rotation
protect the tool since the
6 Error direction forward/reverse lever
setting was changed
changed
during work.
• The set parameter is
Parameter
7 Error
outside the setting range.
error
• The converted torque has
become higher than the
Torque
set upper limit during
8 Torque
exceeded
fastening.
• The converted torque has
become lower than the set
Torque
lower limit during
9 Torque
insufficient
fastening.
• The number of rotations of
the tool's tip has become
Rotation
Rotation
higher than the set upper
10 count
count
limit during fastening.
exceeded
• The number of rotations of
the tool's tip has become
Rotation
Rotation
lower than the set lower
11 count
count
limit during fastening.
insufficient
• The rotation time of the
tool's tip has become
Rotation
Rotation
longer than the set upper
12 time
time
limit during fastening.
exceeded
66
EN
(cont.)
Cause Action
• Check the work
environment.
( Check how the operator is
using the tool.)
• Check the parameter.
• Set the parameter again.
• Check the setting.
• Check the workpiece
conditions.
• Disable the set upper limit
of the converted torque.
• Check the setting.
• Check the workpiece
conditions.
• Disable the set lower limit
of the converted torque.
• Check the setting.
• Check the workpiece
conditions.
• Disable the set upper limit
of the rotation (times).
• Check the setting.
• Check the workpiece
conditions.
• Disable the set lower limit
of the rotation (times).
• Check the setting.
• Check the workpiece
conditions.
• Disable the set upper limit
of the rotation time.
NOK Error
message message
• The rotation time of the
tool's tip has become
Rotation
Rotation
shorter than the set lower
13 time
time
limit during fastening.
insufficient
• Fastening ends before
clutch is activated.
- During fastening, the
tool stopped before
clutch is activated.
Stop before
- During fastening, the
14 Clutch clutch
tool stopped due to
actuation
NOK caused by any
other reason.
Cause Action
• Check the setting.
• Check the workpiece
conditions.
• Disable the set lower limit
of the rotation time.
< When the tool stopped
before clutch is activated>
• Check the work
environment.
• Check the workpiece
conditions.
< When fastening NOK due
to any other reason is
indicated>
• Check the content of the
fastening NOK and take
necessary actions.
67
EN