Panasonic EYADA Serie Manual De Instrucciones página 11

PREPARATION BEFORE USE
Connecting to Power Supply
ATTENTION
⿟ Before connection, set the forward/
reverse lever to the " ○ " position to
lock the trigger switch.
P. 17
⿟ Use only our power supply
(screwdriver cord, power adapter,
and power cord).
Also, do not use the power supply or
cord designed specifically to this unit
to operate other devices.
⿟ When not using the tool for a long
time, you are recommended to
disconnect the power cord from the
outlet. This unit consumes power
even while it is turned off.
Connect the screwdriver
cord to the power adapter
and this unit.
Check the orientation of the
connector and attach it correctly.
Fix it with a joint ring.
Joint ring
Screwdriver cord
Power adapter
(sold separately)
Screwdriver
cord
Joint ring
20
EN
(cont.)
Attach the power cord to the
power adapter.
Power adapter
(sold separately)
Power cord
(sold separately)
Check that the power switch
of the power adapter is OFF.
When the power supply is OFF, the
power lamp is off.
Power switch Power lamp
Connect the power plug to
the outlet.
Example: For Europe
Turn ON the power switch of
the power adapter.
The power lamp lights up green.
Power switch Power lamp
HOW TO USE
Switching Start Modes
This unit has two modes for rotation
start.
Switch them according to the work before
use.
(The factory default is lever start mode.)
■ Switching to Lever Start Mode
Set the forward/reverse lever
to the " ○ " position.
The trigger switch gets locked.
P. 17
Keep the lever depressed (for
approximately 5 seconds)
until the detection lamp
lights up in yellow (for
approximately 1 second).
Then, the buzzer emits three short
beep sounds.
What is lever start mode?
Rotation starts when you pull the
lever. Rotation stops when you
release the lever.
Pull the lever.
■ Switching to Push Start Mode
Set the forward/reverse lever
to the " ○ " position.
The trigger switch gets locked.
P. 17
Press the bit end against a
work table or the like (for
approximately 5 seconds)
until the detection lamp
lights up in yellow (for
approximately 1 second).
Wait for a moment with the bit
holder slightly sunk.
Then, the buzzer emits three short
beep sounds.
What is push start mode?
Rotation starts when you push the
Electric Screwdriver toward the bit.
Rotation stops when you stop pushing.
Press toward
the bit.
NOTE
⿟ Only the selected start mode is
enabled. The unselected start mode
is disabled.
21
EN