Panasonic EYADA Serie Manual De Instrucciones página 17

SETTING VIA A WEB BROWSER
Displaying the Setting Screen.
From the "Parameter", "Batch", and "Device settings" tabs in the screen for the
tool number, make settings of Parameter, Batch, and Device settings.
* To switch the tool, select the desired one from the tool list.
Parameter
Tool list
Batch
Tool list
Device settings
Tool list
32
EN
(cont.)
Parameter Items
Converted torque (Model No. WA only)
[Functional overview]
You can determine the fastening
status by the converted torque of
screw fastening.
Set the lower limit and upper limit
of the converted torque that is
judged as Fastening OK.
• The lower limit setting must not be
higher than the upper limit setting.
What is converted torque?
As with a general screwdriver, the screwdriver's clutch is used to obtain the
desired fastening torque.
Based on the correlation of the screwdriver's outputs (current, voltage and
variation) at the time of clutch activation, this tool converts the fastening torque at
the time of clutch activation into a converted torque (estimated value) and
outputs it.
Use the value as evidence for the fastening result or to capture the trend of the
fastening torque variation during a specific period.
[Default value]
• Upper limit OFF
• Lower limit OFF
• Offset
[Setting value]
• Upper limit OFF Disable
• Lower limit OFF Disable
• Offset
Entering the value with (*) will disable the function.
When the lower limit and the upper limit
are set to 2.00 and 4.00 respectively
Fastening
NG (NOK)
Snugs with
1.99 Nm
Fastening OK if the converted torque when
snugging is within 2.00 Nm to 4.00 Nm.
0.00 Nm
ON Enable / 0.00* Nm to 9.99 Nm
ON Enable / 0.00* Nm to 9.99 Nm
–9.99 Nm to 9.99 Nm
Fastening
Fastening
OK NG (NOK)
Snugs with Snugs with
3.00 Nm 4.01 Nm
33
EN