Kellys E-Bike Instrucciones De Uso página 33

EBIKE
authorization of the STRAVA app.
Turn on the Bluetooth function on your device and make sure it is visible to other devices. Select the
device search.
On the cycle computer, select the CPP option in the Bluetooth settings and turn it on. The Bluetooth
device is searched for.
From the list of available devices on your smartphone, select Panasonic and the specific 6 numbers
and enable the connection.
When the connection is successful, "PAIRING SUCCESFULL" is displayed on the computer screen.
When the Bluetooth function is active, the "DISCONNECT and BACK" options are displayed in the
CPP settings.
In the Wahoo app, add a sensor (your e-bike's cycle computer).
Start recording the ride.
Once the ride information is completed and saved, the data is exported to the STRAVA application.
NOTICE
If CPP and Komoot are enabled at the same time, there may be a problem with device communication
and the navigation arrows may not display well.
HAZARDS
A connection error or other problem may occur while riding. If you need to use a mobile device in
this case, do so only after stopping in a safe place away from traffic and other places where you could
endanger safety and traffic dynamics.
NOTICE
When using mobile apps, a constant GPS signal and a stable internet connection via Wi-Fi or mobile
internet is required. These services may be subject to a fee. Contact your mobile service provider or
Wi-Fi provider for information on pricing and mobile internet data volumes. KELLYS is not responsible
for any discrepancies in the billing of these services.
The drive and electronic shifting system, as well as the lighting (if equipped) and the e-bike display
also work in the event of a loss of mobile signal and GPS signal.
CHARGING EXTERNAL DEVICES FROM THE SYSTEM SCREEN
The Panasonic system allows external devices (e.g. a mobile phone) to be charged via USB from the
e-bike battery.
The procedure for charging an external device:
1. Switch on the e-bike system
2. Pull out the rubber MicroUSB plug on the cycle computer
3. Connect the USB OTG cable/adapter to the MicroUSB socket
4. Connect an external device
5. Charging starts automatically when connected and the USB connection symbol appears at the top
of the main screen
USB output parameters: 5V DC, max. 1 A
NOTICE
Place the external device on a stable surface while charging. Failure to do so may cause the equipment
to fall and cause damage.
Some external devices cannot be charged in this way. The connection has been tested on multiple
devices, yet may not be compatible with your device.
Back up your data before connecting, as data may be lost in the event of a connection error.
Do not connect the device during rain or in a humid environment.
After charging, close the USB socket with the rubber cap.
When connecting, make sure that the plug to be connected is oriented correctly.
If the device is connected to the cycle computer while riding the e-bike, keep the device securely
clamped in a suitable mount near the cycle computer (on the handlebars or on the top frame tube
EN
OWNER'S MANUAL
31