KEB COMBIVERT F5 Serie Manual De Instrucciones página 104

Error Diagnosis
Display COMBIVIS
A.nOL no ABN.STOP overload
A.nOL2 no ABN.STOP overload 2
A. OH A.STOP overheat pow.mod
A.OH2 ABN.STOP motor protect.
GB
A.OHI ABN.STOP overheat int.
A. OL ABN.STOP overload
GB
A.OL2 ABN.STOP overload 2
A.PrF ABN.STOP prot. rot. for.
A.Prr ABN.STOP prot. rot. rev.
A.SbuS ABN.Bus synchron
A.SEt ABN.STOP set
A.SLF ABN.Software limit switch forward
A.SLr ABN.Software limit switch reverse
GB- 34
Value Meaning
98 Warning: no more overload, OL counter has reached 0 %.
101 The cooling time after "Warning! Overload during standstill"
has elapsed. The warning message can be reset.
89 A level can be defined, when it is exceeded this warning is
output. A response to this warning can be programmed (see
chapter 6.7 "Response to errors or warning messages").
97 Warning: electronic motor protective relay has tripped. The
response to this warning can be programmed (see chapter
6.7 "Response to error or warning messages").
87 The temperature in the interior of the inverter lies above the
permissible level. The switch off time was started. The
programmed response to this warning message is executed
(see chapter 6.7 "Response to errors or warning
messages").
99 A level between 0 and 100 % of the load counter can be
adjusted, when it is exceeded this warning is output. The
response to this warning can be programmed (see chapter
6.7 "Response to errors or warning messages").
100 The warning is output when the standstill continuous current
is exceeded (see technical data and overload
characteristics). The response to this warning can be
programmed (see chapter 6.7 "Response to errors and
warning messages"). The warning message can only be
reset after the cooling time has elapsed and A.nOL2 is
displayed.
94 The drive is driven onto the right limit switch. The response
to this warning can be programmed (see chapter 6.7
"Response to errors and warning messages").
95 The drive is driven onto the left limit switch. The response to
this warning can be programmed (see chapter 6.7
"Response to errors and warning messages").
103 Synchronization over sercos-bus not possible. The response
to this warning can be programmed (see chapter 6.7
"Response to errors and warning messages").
102 Warning: set selection: It has been attempted to select a
locked parameter set. The response to this warning can be
programmed (see chapter 6.7 "Response to errors or
warning messages").
104 The target position lies outside of the limit defined with the
right software limit switch. The response to this warning can
be programmed (see chapter 6.7 "Response to errors or
warning messages").
105 The target position lies outside of the limit defined with the
left software limit switch. The response to this warning can
be programmed (see chapter 6.7 "Response to errors or
warning messages").