Decathlon B'twin Manual Del Usuario Y Garantía página 5

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 36
You can adjust the brake system as follows:
Brake pads
1/ Check the pad is aligned with the edge of the rim.
2/ Check the distance of the pads from the rim (1 to 3mm for optimum braking).
3/ Always lift the pads off the rim a bit to the rear.
4/ Check that the V-Brake or Cantilever calipers are symmetrical.
Check that the "left and right" caliper return springs are balanced as illustrated below:
V-Brake
ALUMINIUM TUBE
TENSION SPRING ADJUS-
SYMMETRICAL SPACE
Calliper
SIDE PULL
CABLE
Nut
PULL THE CABLE
5/ Adjusting cable tension
Caliper brakes (U-type)
The braking device is located inside the hub: the brake can be activated by a lever (drum
brake) or by the pedals (coaster brake)
Coaster brake: the brake is activated when you peddle backwards. The brake must be applied before the crank has rotated 60 degrees (1/6 turn). The chain activates the brake. It's
important to check that the tension is correct to prevent chain derailment. The permissible range of vertical movement for the chain is detailed in the «Adjusting chain tension» section.
SCREWDRIVER
LESS TENSION
MORE TEN-
SION
TING SCREW
SAFETY HOOK POSITION
+Easy brake
V-Brakes + EASY BRAKE RELEASE,
The axis on the cable metal pipe should be inserted into its housing in THE BRAKE CALLI-
PERS. CHECK THE EFFICIENCY OF THE BRAKE AFTER FITTING IT
HANGER
5
Cantilever
HANGER BOLT
PULL THE CABLE
rim
Brakes can be V-type brakes, mechanical
disk brakes, Cantilevers, or Roller brakes.
CABLE
PINCH BOLT

Publicidad

Tabla de contenido
loading

Tabla de contenido