4 INTRODUCTION TO THE SYSTEM
4.1 General guidelines
hyperion allows images to be captured in real time. In order to view, assess and save the images, hyperion has to be
connected to a Personal Computer that has the minimum requirements stated below and a program to view x-ray im-
ages has to be installed.
The PC is not included with the device. Use exclusively certified PCs according to the safety regulations in force.
Images can be saved without using the PC if a memory card is available (the same as the one used in most digital
cameras) and inserted in the port found on the bottom right-hand side of the control panel.
In order to assure a correct startup, Hyperion MRT must be turned on without any memory card inserted. In case
that error code "E005" is reported by the consolle, please remove SD card and restart Hyperion.
Carefully read the manual that deals with the x-ray image software manual to correctly use the program.
Installation should be done by a qualified technician to configure data sharing in a local PC network.
4.2 Personal computer
The computer which hyperion is connected to should satisfy the following minimum requirements:
Component
Processor
Operating System
Space on hard disk
RAM memory
Video board
Other peripherals
Network
5 PREPARING THE UNIT
5.1 Turning on the system
Press the power button on the back of hyperion at the base of the column to turn it on.
The power button is labelled in the following manner:
POWER
I
ON
O
OFF
5.2 Selecting the exam
This button is used to scroll the main groups of procedures available.
The selected group is indicated by an arrow on the left side of the screen.
These buttons are used to scroll the projections available within the selected group.
42
EN
hyperion
- OPERATING INSTRUCTION
Requirement
Processor 1 GHz or higher
Windows XP - Windows Vista - Windows 7
1 Gb minimum
512Mb minimum 1Gb recommended
Video card minimum resolution 1024 x 768 with 16
million colors
CD-ROM
Network card compatible with Microsoft Windows XP / Vista / Windows 7
Local network at 100 Mbit 10 Tbase with HUB-switching recommended
Requirement for 3DTS
Intel Pentium IV /AMD @ 2.4 GHz,
SSE 2
10 Gb
2 Gb Windows XP/ 3 Gb Vista-
Windows 7
min 1280 X 1024 16 million colors