Amiea Med EXCEED Instrucciones De Uso página 39

5.1 Positioning the device
CAUTION
Reduced functionality due to electromagnetic inter-
ference
Portable and mobile HF communications devices, such
as mobile phones or WLAN routers, can influence the
functionality of the device through the transmission of
electromagnetic radiation. Safe operation of the device
can no longer be assured.
Avoid sources of interference by ensuring that port-
E
able or mobile radio devices are not operated in the
vicinity of the device.
Inform your patients about the risk of sources of inter-
E
ference.
ATTENTION
Damage to the device through inadequate stability
If the device is not positioned safely, safe operation is not
guaranteed. The device could fall and become damaged
during operation.
Place the device on a clean, firm and level surface.
E
Ensure that the buttons and the display of the device
E
remain freely accessible during use.
Never place the device on or underneath other
E
devices.
Position the device such that the recommended safety
E
distance from possible sources of interference is main-
tained. You can find information on the recommended
safety distances in the chapter Information on electro-
magnetic compatibility.
Position the device so that the power supply is access-
E
ible at all times.
5.2 Connecting the power supply
The device may only be operated with the power supply
cited in the operating manual of the device. The mains
voltage must match with the device voltage cited on the la-
bel of the power supply.
If there is no suitable country-specific adapter included
E
in the scope of delivery, contact an authorised dealer
(see also chapter "10 Questions and problems" on
page 47).
EXCEED
To remove the existing country-specific adapter, if neces-
sary:
Pull back and hold the catch for the adapter and at the
E
same time lift the country-specific adapter out of the re-
cess in the power supply.
Fig. 1: Remove country-specific adapter
To insert the desired country-specific adapter:
Place the country-specific adapter in the recess of the
E
power supply as shown below.
Press the adapter into the plug-in power unit until the
E
catch can be heard to engage.
Fig. 2: Inserting country-specific adapter
In order to establish the power supply:
Insert the DC plug of the power supply into the socket
E
for the power supply (
Fig. 3: Socket for the power supply
Insert the power supply into a mains outlet.
E
The standby LED illuminates blue.
Make sure that the power supply is accessible at all
E
times.
) on the rear of the controller.
EN 39