Publicidad
Idiomas disponibles
Idiomas disponibles
6.2 DAILY INSPECTION AND MAINTENANCE
- Before beginning any maintenance or service, familiarize yourself again with all instructions,
restrictions and recommendations in this manual.
- Always remove the key from the ignition and disconnect the spark plug cables before
performing any cleaning, maintenance or repairs.
- When working, always wear appropriate work clothes and shoes. When handling the cutting
blades or during activities that pose a cutting risk, wear appropriate work gloves.
- Avoid spilling fuel, oil or other hazardous substances.
Dispose of used oil, fuel or other hazardous substances according to applicable environmental
protection laws.
6.2.1 BEFORE STARTING WORK
TYRE PRESSURE INSPECTION
Inspect the tyre pressure regularly and make sure it meets requirements. Maintaining the specified
pressure is important to even mowing. Other pressure values can hamper driving and even result in loss
of control.
The air pressure in the front and rear tyres must be within the range of 80 - 140 kPa, and the difference
between the individual tyres can be ± 10 KPa.
CONTROL OF ENGINE OIL LEVEL
Place the lawn mower mower on a level surface. Open the bonnet and unscrew the cap of the filling port.
Unscrew the dipstick, wipe it clean, reinsert it and screw it back in. Then unscrew it again and read the
oil level.
The oil level must be between the two marks on the dipstick. If it is not, add motor oil until it reaches
the "FULL" mark.
Further information on checking and adding oil is given in a separate manual provided by the
engine manufacturer.
CHECKING CABLES AND SCREW CONNECTIONS
Visually inspect the state of the cables and manually check tightness of screw connections.
CHECKING BRAKE FUNCTION
Check the brakes for proper operation. Proceed as follows:
Set the machine on a level surface and shut off the engine.
Press the brake pedal and engage the parking brake.
Use the bypass lever to cut off power to the rear wheels.
Try to push the machine forward manually. If the rear wheels turn, brake service is needed. Contact
an authorized service facility that will adjust them.
6.2.2 AFTER FINISHING WORK
MACHINE SETTINGS
After mowing, raise the mowing mechanism to the highest position and shut off power to the rear wheels.
Turn off the ignition, press the brake pedal and use the parking brake to keep the machine in position.
On machines with BS15 (15.5-hp) engines, close the fuel intake.
CLEANING THE MACHINE
Remove all dirt and clippings from the tractor's surface, the removal tube and the mowing mechanism.
Thoroughly clean the grass catcher's fabric bag. If grass is stuck to it, the machine can't fill the grass
catcher as well.
WASHING THE MACHINE
Before washing, park the machine on an appropriate level surface.
48
Publicidad
