Blackmagic Design HyperDeck Extreme 4K HDR Manual De Instrucciones página 12

Tap on the audio meters to display and adjust the speaker level
2 Soft Touch Buttons
The front panel features 7 soft touch buttons so you can quickly access traditional transport
controls or apply LUTs. Each button is backlit when the unit is powered so you can easily
see the buttons when the unit is installed in low light conditions, such as a dubbing facility.
If you are using a RS-422 device to control playback and recording remotely, press the
'rem' button. This will allow the your HyperDeck to be controlled externally from a device
such as the HyperDeck Extreme Control or the HyperDeck Ethernet Protocol. The button
will illuminate to indicate the remote feature is active. The button will also flash when the
'identify HyperDeck' checkbox is selected in HyperDeck Setup.
The five transport control buttons including the most commonly used functions for recording
and playback; record, stop, play, fast forward and rewind. Use these buttons for immediate
control over the record and playback functions.
When active the selected button will illuminate.
3D LUT lets you toggle the active display LUT on the HDR LCD display. The button will
illuminate when active.
For more information on LUTs, including how to set your LUT and display it on the LCD and
or monitor out, see the 'LUTS' section later in this manual.
NOTE It is worth noting that if the unit does not have a valid signal connected,
pressing the 'record' button has no effect on the unit. This is the same for the play, fast
forward and rewind buttons when no storage media is connected.
HyperDeck Extreme Front Panel 12