Blackmagic Design HyperDeck Extreme 4K HDR Manual De Instrucciones página 69

You can use the soft touch transport controls or the search dial
and mode buttons to control your HyperDeck Extreme
Tap on the 'shuttle' button above the search dial. You can now turn the dial right and left to
shuttle through your video. Press the 'stop' button to exit shuttle mode. Now press 'play'
for real time playback, or the skip buttons to navigate from recorded clip to recorded clip.
The next section of the manual provides a basic workflow example showing how to control
a broadcast deck for archiving material to a HyperDeck Extreme.
HyperDeck Extreme Control Workflow
The following example features a traditional broadcast tape deck recording to a HyperDeck
Extreme recorder, but you don't need to use a HyperDeck with the HyperDeck Extreme
Control. You could connect two or more traditional broadcast decks and dub from tape to tape
or connect up to 8 decks to control simultaneous playback at the press of a button.
Connecting your RS-422 Devices
RS-422 connections on the rear of the HyperDeck Extreme Control allow up to 8 RS-422
enabled decks and devices to be attached from the rear of your HyperDeck recorder or
broadcast deck to the RS-422 connections on the rear panel of the HyperDeck Extreme
Control. Up to 8 separate devices can be connected.
1 Connect a 9 pin serial cable from the RS-422 connection on your tape based deck to the
first RS-422 connection on the controller.
2 Now connect a serial cable from the RS-422 connection on your HyperDeck recorder to
the second RS-422 connection on the HyperDeck Extreme Control.
3 You can repeat these steps to connect up to 8 devices.
HyperDeck Extreme Control Workflow 69