Blackmagic Design HyperDeck Extreme 4K HDR Manual De Instrucciones página 91

Idiomas disponibles

Rack Mounting HyperDeck Extreme

The HyperDeck Extreme and HyperDeck Extreme Control can be rack mounted into a

broadcast rack or road case using the HyperDeck rack mount kit.

Sitting at three rack units high and half the width of a standard rack, HyperDeck Extreme can

be mounted side by side or individually using the blanking panel provided with the kit.

The HyperDeck Extreme Rack Kit contains the following items:

Preparing HyperDeck Extreme or HyperDeck Extreme Control

for individual rack installation:

Position the blanking panel on one of the sides of your HyperDeck unit, depending on

whether you would like the unit to sit on the right or left of the shelf. The front face of the

blanking panel should be parallel with the front panel of the unit.

2 x Rack ears

Attach rack 'ears' to the outside edge of

HyperDeck Extreme for mounting in a rack.

1 x Half rack width blanking panel

The blanking panel has a mounting ear on one side

so you can cover the empty rack space if you are

installing a single unit. The illustration shows the

ear on the right side. Simply rotate the panel 180° to

mount it to the other side.

2 x Support brackets

The T-shaped support brackets attach underneath

the HyperDeck Extreme units where the two units

meet at the front and the rear to provide support.

Blanking panel

2 x Cable tab insert

bracket screws