Blackmagic Design HyperDeck Extreme 4K HDR Manual De Instrucciones página 75

Idiomas disponibles

When using 'position' with a tape based deck, the position indicator will

improve with time as the deck is queried by the controller.

To locate your timecode point, make sure your 'player' has a reference signal and is in 'remote'

mode. Then on the controller:

Press the 'player' button if it is not already illuminated

Press the 'shuttle' button. Once pressed, the button will illuminate.

Rewind your tape by turning the search dial knob to the left until you feel the clutch engage.

You are now rewinding at full speed and the tape will be spooling back to the start.

Once you are nearing the timecode point, turn the dial back to the center. Once the knob is

near the center stop position you will feel a tap on the dial to let you know.

Press the 'jog' mode button. The jog button will now be illuminated. The dial will now spin

freely and you can turn it to find your desired timecode. The faster you turn the dial, the

faster the media will jog.

Now that you have found your timecode in point, you can use the four soft touch timecode

buttons to define your in and out timecode points. These timecode entry buttons operate the

same way as they do on traditional broadcast decks.

To set your timecode points:

Press 'entry' and 'in' to select your in point and release the buttons. The 'in' button will be

illuminated to confirm an 'in' point is selected.

Now you can use the transport controls or search dial to locate your 'out' point. Once you

have found your out point, set it by pressing the 'entry' and 'out' buttons together.

Both the 'in' and 'out' buttons will now be illuminated.

The trim function lets you adjust your in and out points frame by frame. If you want to move

either of your timecode points by individual frames, you can do this by using the 'trim' buttons.

To trim your timecode frame by frame:

Press the 'in' button and then either trim '-' or trim'+' to move the in point backwards or forwards

one frame at a time.

Once your 'in' point is set, you can repeat the above steps to locate the 'out' point using the

search dial.

Press the entry and in buttons to set your in point

Move your in point forward by a frame by pressing

the 'in' button and the trim '+' button

HyperDeck Extreme Control Workflow