To return to the main display, tap the menu icon in the top right corner. Your input and codec
selection will appear on the top toolbar of the main display along with the video source
on the LCD.
TIP
For more information on codecs and available quality settings, see the 'codec and
quality' section in the record menu later in this manual.
Starting Record
Now that you have set your source and codec, you can start recording.
Press the 'record' button on the front panel, or tap the red record icon on the touchscreen.
You can see your HyperDeck is recording because the record button will illuminate red
along with the timecode display and media icon. To stop recording, simply press either the
touchscreen or front panel 'stop' button.
Media Warning Indicator
If you are recording Ultra HD or high quality 8K video using slower media, you may experience
problems with your media. For example, 8K recording uses a higher data rate compared to
Ultra HD, so your CFast cards need to be the fastest available. If there are problems with your
media during recording, you will see a red exclamation icon above the audio meters on the
touchscreen overlay.
An exclamation mark will appear in the lower right hand corner of
the display if problems with your media have been detected
Recording
9