toscano TDS600 Serie Manual De Usuario página 219

External
E-20
interference failure
Internal interference
E-21
failure
E-22
PID reference loss
(A-22)
E-23
PID feedback loss
(A-23)
E-24 PID error
(A-24) amount abnormal
Start terminal
E-25
protection
E-26 Communication
(A-26) failure
E-27 Reserved
E-28 Reserved
E-29 Reserved
E PROM read
2
E-30
and write
(A-30)
wrongly
Temperature
E-31 detecting
disconnection
The interruption protection
triggered, but none of the actual
overcurrent, overvoltage and short
circuit signals have been detected
Internal disturbance serious
PID given loss threshold setting is
not reasonable
External given disconnection
The control board anomaly
PID feedback loss threshold setting
is not reasonable
Feedback signal
disconnection
The control board anomaly
PID error abnormal detection
threshold setting is not reasonable
The control board anomaly
Terminal command effective when
power on .
Baud rate set improperly
Serial port communication error
Failure warning parameter
improperly
Upper device doesn't work
Mistake take place when read or
write control parameter
Temperature sensor fault
The temperature detection circuit
anomaly
7. Troubleshooting
is
Press "STOP/RESET" button to reset or
add external power supply filter from
power input side
Power off and restart, if the failure
persists, seek the manufacturer or dealer
service
To reset the relevant parameters
Check external given wiring
Look for service from manufacturer or
agent
To reset the relevant parameters
Check external feedback signal wiring
Look for service from manufacturer or
agent
To reset the relevant parameters
Look for service from manufacturer or
agent
Check the external input terminal state
set Baud rate properly
Press "STOP/RESET" key to reset,
look for service
set
Modify F05.04, F05.05
Check if upper device work and wiring is
correct
Reset by pressing "STOP/RESET"
Look for service from manufacturer
or agent
Look for service from manufacturer or
agent
Look for service from manufacturer or
agent
215