Stop Suddenly When Running; Gasoline Engine Is Excessively Hot - Lavorwash 160F Manual Para El Usuario

IV. STOP SUDDENLY WHEN RUNNING
TROUBLE
Stop suddenly Fuel supply system.
when running.
Ignition system.
The other.
V. GASOLINE ENGINE IS EXCESSIVELY HOT
TROUBLE
Gasoline en- Improper ignition time.
gine is exces-
Insufficient engine oil supply.
sively hot.
Exhaust pipe is clogged.
Flow guard is leaking.
Dirt or something like this fill up among air
cooling fins.
Cooling fan is loosen, losing function.
Cylinder, piston or piston ring is worn, resulting
in air flow between cylinder and crankcase.
Tie rod deformation makes piston and cylin-
der bushing side wear.
Improper adjustment of engine speed pro-
duces excessive rotational speed.
Bearing of crankshaft is burnt out.
NOTE
The gasoline engine should run under certain temperature. Generally, permitting temperature
at the flow guard outlet is between 80~100° C, while the temperature of the crankcase is about
60° C under the magneto. If temperatures surpass the limits, it is an indication that the gasoline
engine is excessive hot.
CAUSE
Fuel is used up.
Carburetor is clogged.
Floater is leaking.
Needle valve sticks.
Spark plug is struck through,
or short-circuited by carbon
deposit.
Side electrode of spark plug
is dropped out.
Hi-voltage wire is dripped
out.
Engine oil in the crankcase is
insufficient.
Ignition coil is struck through
to be short-circuited.
Parking wire is located on
the engine body.
Cylinder is pulled consider-
ably, valve falls off.
CAUSE
REMEDY
Fill fuel.
Check fuel line and dredge.
Repair.
Dismantle floater
chamber and eliminate it.
Replace spark plug.
Replace spark plug and re-
move the dropped object.
Connect it.
Add engine oil until it arrives
the upper level.
Replace ignition coil with new
one.
Find out meeting and insu-
late.
Repair or replace damaged
parts.
REMEDY
Adjust ignition advance angle properly.
Refill sufficient engine oil.
Dredge exhaust pipe.
Repair leakages.
Clear away dirt or something like this.
Reinstall it well.
Replace tie rod.
Replace the worn part.
Readjust engine speed to proper val-
ue by speed regulator.
Replace main bearing.
EN
39