Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
15.7.3.
V-tail compensation inputs
for AILERON, ELEVATOR and RUDDER........54
15.8.1.
Dual-Rate for AILERON, ELEVATOR, RUDDER
) DR
Menu: (
CONTRL
15.8.2.
) EXP
Menu: (
15.9. Activating flight phases.....................................55
15.9.1.
What is possible with flight phases?
15.9.2.
Menu: (
,
15.9.3.
On-screen display of the active flight phase
15.9.4.
Menu: (
15.9.5.
Menu: (
with the ACRO model type ...............................57
Menu: (
16.
Model type: HELI
16.1. What is possible with the HELI type? ...............59
16.1.1.
Important information on flight phases!
16.1.2.
Notes on the terms ROLL, PITCH-AXIS and YAW,
as used in the menus
16.2. Preparing the model .........................................59
16.2.1.
Determining the rotor head type
16.2.2.
Connecting the servos to the receiver
16.3. Preparing the transmitter ..................................60
16.3.1.
Menu: (
16.3.2.
Menu: (
,
16.3.3.
Transmitter controls for the HELI type
16.3.4.
Menu: (
,
16.3.5.
Selecting the stick position for throttle idle / collective
pitch minimum
Menu: TH
R (Reverse)
16.3.6.
Throttle trim and the collective pitch stick
16.3.7.
Selecting the right-hand slider minimum setting forward
/ back (Throttle Limiter and Direct Throttle)
SETUP, MODEL
Menu: (
Setting up Throttle Check Warning: "TH >0"
16.3.8.
16.4. Setting up the swashplate servos.....................63
16.4.1.
Checking and correcting the direction of rotation
of the swashplate servos for COLLECTIVE PITCH 63
16.4.2.
Checking the direction of rotation
of the swashplate servos for ROLL and PITCH
16.4.3.
Setting up the swashplate for rotor head types 1 to 4 64
) PITCH.................................64
16.6. Everything about throttle...................................65
16.6.1.
The meaning of Limiter, Curve, Minimum, Trim, DTC
and Throttle Cut
16.6.2.
Setting up the throttle servo for a glow motor
54
54
54
55
55
56
56
56
57
57
58
58
59
59
59
59
60
60
61
61
) TYPE
61
62
62
) SP+L R
62
63
63
65
65
Operating Instructions
16.6.3.
Throttle for electric helicopters
16.6.4.
Menu: (
16.6.5.
Menu: (
16.6.6.
Menu: (
Menu: TAIL.....................................................67
16.7.1.
Checking / correcting the direction of rotation, centre
and maximum travel of the tail rotor
Setting the YAW input for the tail rotor
16.7.2.
16.7.3.
Menu: (
MIXER
Setting the CP input for the tail rotor (REVO-Mix) 68
16.7.4.
Setting an OFFSET for the tail rotor
16.7.5.
16.8.1.
Setting gyro gain
16.8.2.
CONTRL, GYRO
Menu: (
16.8.3.
Checking the heading function
for ROLL, PITCH-AXIS and YAW.....................70
16.9.1.
Setting Dual Rate for roll, pitch-axis and yaw
CONTRL
Menu: (
16.9.2.
Menu: (
16.10.Activating flight phases .....................................71
16.10.3. On-screen display of the active flight phase
16.10.4. Copying flight phases
PHASES
Menu: (
Menu: (
17.
The free mixers MIX 1, 2 and 3
17.2. Adjusting the mixer effect .................................73
17.3. Erasing the free mixers.....................................74
18.
Menu: MEMO
19.
Timers 1 and 2, operating time
19.1. Timer 1..............................................................76
19.1.1.
Assigning a switch
TIMER
Menu: (
19.1.2.
Menu: (
Page 3
) TH
) CP ZRO
,
TAIL
) GYRO .......................................69
) HEADG
) DR
V-ROT .......................72
) MIXDEF..................................73
) GO TO ......................................74
) NEW............................................75
) NAME .........................................75
) COPY .........................................75
) DELETE ....................................76
66
66
66
67
67
68
68
69
69
69
70
70
70
71
71
71
72
72
73
74
76
76
76
Publicidad
Capítulos
Tabla de contenido
