Preparing The Transmitter; Setting Up A New Memory For The Heli Type Menu; New - Multiplex Cockpit SX Manual De Instrucciones

C SX
OCKPIT
FLAP
7
Collective
AUX 1
pitch
6
Gyro
3
Tail rotor
Fig. 16.1.: Helicopter with separate actuation of collective
pitch, roll and pitch-axis (mechanical rotor head mixing)
Additional rotor head types:
for CCPM rotor heads
3-point
90° head
ROTOR
2
TYPE
Flug-
Direction
richtung
of flight
ROTOR
-2
TYPE
Flug-
Direction
richtung
of flight
Receiver
output
1 180° / 0°
2 270°
3 Yaw
4 90°
5 Throttle
6 Gyro
7 AUX 1
Note:
The servo positions (in degrees) assume 0° for the direction
of flight, and proceed from that point in a clockwise direction.
4
2
Pitch axis
1
Roll
5
Throttle
ESC
Rotor head type
3-point- 4-point
120° head 90° head
3 4
-3 -4
assigned to
180° / 0° 180° / 0°
300° / 240° 270°
Yaw 0° / 180°
60° / 120° 90°
Throttle Throttle
Gyro Gyro
AUX 1 Yaw
Throttle / ESC
Gyro
FLAP
7
AUX 1
Tail rotor
Fig. 16.2.: CCPM head with 3-point 120° linkage
16.2.2. Connecting the servos to the receiver
Connect the servos, speed controller and gyro to the
receiver in the sequence stated in the table adjacent to
the schematic rotor head diagrams (
Important:
The swashplate can only be set up correctly if the ser-
vos are connected to the correct receiver outputs.
So: please check one last time before you proceed!

16.3. Preparing the transmitter

The model memory must be set up for the helicopter
before you can check the directions of servo movement
on the model itself. This involves setting the stick mode
and selecting the appropriate swashplate type.
When preparing the transmitter for the model you will
need to carry out the following steps:
• Setting up a model memory
• Setting the stick mode
• Familiarising yourself with the transmitter
controls (sliders / switches)
• Selecting the rotor head type
• Determining the transmitter control positions
for idle and collective pitch minimum
• Setting up Throttle Check
16.3.1. Setting up a new memory
for the HELI type
Menu: (
Moving to the NEW menu:
to MENU,
to MEMO,
to NEW,
The last used model type appears as the default.
Turn the 3-D digi-adjustor (
model type. Confirm the model type with a brief press
( ); this automatically takes you to the "IN MEM" menu.
Page 60
300°
180°.
16.2.1.).

) NEW

MEMO
(SETUP appears)
(GEH ZU appears)
) to select the "HELI"
60°
16.3.1.
16.3.2.
16.3.3.
16.3.4.
16.3.5.
16.3.6.