Adjusting The Servo Centre Menu: ( Servo ) Centr; Setting Servo (Control Surface) Travels Menu: ( Servo ) Travl - Multiplex Cockpit SX Manual De Instrucciones

Ocultar thumbs Ver también para Cockpit SX:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

It is not possible to state a defined direction of rotation
(left or right), as different servo types respond dif-
ferently to control signals.
A brief press
on the 3-D digi-adjustor concludes the
process. The values are stored, and you can continue
with another servo.
The procedure for switching to another servo:
Left to EXIT
5.
Confirm
6.
Left to EXIT
7.
Now continue with step 3 (selecting the servo) in the
preceding table.
The correct control surface response at the model:
Stick
Stick
RUDDER
left
ELEVATOR
back (pull)
AILERON
left
Note for V-tail models:
It is not necessary to check the direction of rotation
If your model features a V-tail, do not check the direc-
tion of rotation of servos 2 and 3 (elevator / rudder) at
this point. The directions of rotation can only be
checked and corrected when the V-tail mixer has been
activated (
13.7.1.).
13.4.2.
Adjusting the servo centre
) CENTR
SERVO
Menu: (
Minor deviations in the control surface neutral position
can be corrected by adjusting the servo centre. Any
major deviation must first be corrected mechanically.
REV appears
SERVO1 appears
Movement at the
Control surface,
viewed from the
tail
left
up
left aileron up
Operating Instructions
This is the procedure:
Action
Left to MENU
1.
Confirm
Right to SERVO
2.
Confirm
3.
Select servo
4.
Open selected servo
5.
for setting
Open CENTR
6.
for setting
The current setting for CENTRE flashes in the bottom
line. If you are setting up a new model, the centre is set
to "0%" by default.
The centre can be set to any value within the range -
110% to +110% using the 3-D digi-adjustor.
A brief press
on the 3-D digi-adjustor concludes the
process. The value is stored, and you can continue
with another servo.
Switching to another servo:
Left to EXIT
7.
Confirm
8.
Left to EXIT
9.
Now continue with step 4 (selecting the servo) in the
preceding table.
13.4.3.
Setting servo (control surface) travels:
Menu: (
The building instructions for your model should include
a table of recommended control surface travels.
In the TRAVEL menu you can set the travels to the
desired value "electronically", separately for each side
of centre.
Servo travel can be set to any value within the range -
110% to +110%.
Page 23
Effect
SETUP appears
SERVO1 appears
Servo number appears
CENTR appears
CENTR appears
SERVO1 appears
) TRAVL
SERVO

Publicidad

Tabla de contenido
loading

Tabla de contenido