Switching On, Using The Transmitter; Switching On For The First Time - Multiplex ROYALpro 7 Manual De Instrucciones

Starting from the trim centre position, the maximum
trim range is twenty increments in both directions. The
trim increment (step, or adjustment rate) can be set to
any of four magnitudes (0.5%, 1.5%, 2.5%, 3.5%) (
15.4.2.).
!
Note regarding increment size and trim range:
the number of steps remains the same even if
you change the size of the trim increment,
with the result that both the trim range and
the absolute trim value also change! This
means: if you alter the trim increment size,
you must remember to re-trim the model.
The current trim value is displayed in graphic form on
the screen, but can also be read off as a numeric
value for each transmitter control (Parameter Trim
15.4.1.).
The type of graphic display can be selected in the
Status screen (Parameter Trim graph (Trim graphic)
14.1.4.).
Tip!
Resetting the trim to Centre:
Simultaneously pressing both trim buttons for any
stick axis resets the trim for the currently active flight
phase to Centre. This also applies to throttle trim.
10. Switching on, using the
transmitter
! pro
The ROYAL is supplied with the transmitter
battery partially charged. The pack must be fully
charged before you use the transmitter. Please refer
to the charging notes (
10.1.

Switching on for the first time

The very first time you switch the ROYAL
mitter on is a special case. When switched on, the
transmitter displays the following menu:
ROYALpro12
Select language:
Sprache wählen:
skip/später
English
Deutsch
In this menu you select the language which the trans-
mitter will use for the menus and the names of the
pre-defined mixers and assignment lists. We recom-
mend that you select the appropriate language when
you first switch the transmitter on:
Select the appropriate language using the
buttons, then press ENTER to confirm your choice.
If you select English:
a. English will be used as the menu language.
b. The pre-defined mixers are defined using English
terminology:
ELEVATR+, AILERON+, ...
The mixer inputs are also described in English:
Aileron, Elevator, Rudder, ...
If you change the selected language to German
(Deutsch) in the menu Setup, User, then the
names of the pre-defined mixers will continue to
appear in English, but the German terms will be
used for the mixer inputs:
Quer, Höhe, Seite, ...
It is possible to change the names of all the four-
teen free mixers to anything you like (Name pa-
rameter). This is accomplished in the menu Setup,
Mixer def..
Deutsch
If you select (German):
a. German will be used as the menu language.
b. The pre-defined mixers are defined using the
German terminology:
HÖHE+, QUER+, ...
The mixer inputs are also described in German:
Quer, Höhe, Seite, ...
skip/später
If you select
a. English will be used as the language.
b. Next time you switch on, the same menu will ap-
pear, and you can repeat the language selection.
Manual
8.).
pro
trans-
2.53 DE/EN
Only these
buttons are
active!
ENTER
and
(not recommended):
21