As long as the on-screen warning is visible, ...
the servo assigned to throttle (or the speed control-
ler) remains in the Idle position (or motor OFF),
and
all other control functions can still be operated nor-
mally.
The throttle lock is terminated when ...
the throttle control is moved to the Idle position (or
motor OFF),
or
the Throttle CUT control is operated (default button H)
or
you press the REV/CLR button.
!
Caution! The motor might start to run!
If you override the throttle lock using the REV/CLR
button or Throttle CUT, the throttle channel will jump
to the value defined by the assigned throttle control.
10.4.2.
Throttle-check for model helicopters
Helicopter throttle is affected by the following trans-
mitter controls:
a. Throttle CUT switch (default: button H).
b. Direct Throttle switch
(DTC = Direct Throttle Control, default: switch N).
c. Collective pitch stick via the throttle curve.
d. Throttle limiter (default: slider F).
This warning appears on-screen if:
Throttle-Check (Check Thr.) is set to ON (
and
the collective pitch stick is not at the Idle position
(collective pitch minimum)
and
the Throttle CUT switch is not active.
As long as the note is visible on the screen, ...
the servo assigned to throttle (or the speed control-
ler) remains in the Idle position (or motor OFF)
and
all other control functions can still be operated
normally.
The throttle lock is terminated when ...
the collective pitch stick is moved to the Collective
Pitch Minimum position (provided that: point P1
on the throttle curve is lower than or equal to the
set value for Throttle Minimum Min.)
or
EMERGENCY throttle OFF is operated (default:
button H)
or
the throttle limiter is moved to the Minimum position
or
you press the REV/CLR button.
!
Caution! The motor might start to run!
If you override the throttle lock using the REV/CLR
button or Throttle CUT, the throttle will jump to the
value defined by the assigned throttle control.
10.5.
Two buttons have special functions which only apply
when you switch the transmitter on:
a. Button
(Setup)
Indicator for
the throttle
You can now select the channel on which you wish to
and throttle
operate using the 3-D digi-adjuster or the
limiter con-
!
trols
For safety reasons the channel selection option
only appears if the transmitter is first switched OFF,
and then switched ON again.
10.4.)
b. Button
(allocate 3-D digi-adjuster / scan)
For information on the function and operation of the
scanner please refer to the separate scanner instruc-
tions and Chapter (
Switching on to change the
transmitter frequency, or to use
the Scanner
L
If you hold this button pressed in
when you switch the transmitter on,
the menu for selecting the transmis-
sion channel (transmitter frequency)
appears as soon as you release the
button:
F
If you hold this button pressed in
when you switch the transmitter on,
the "Scan" menu (or a message in-
forming you that no scanner is present
in the transmitter) appears on the
screen when you release the button:
20.6.2.).
Manual
buttons.
23