Setting Up Free Mixers - Multiplex ROYALpro 7 Manual De Instrucciones

ON , Mx1 , Mx2 , Mx3 , OFF
The assigned switch and the switch status are dis-
played in the list Assignment , Switches .
16.1.4.

Setting up free mixers

For fixed-wing model aircraft!
"Free mixers" are all those mixers which are defined in
the menu Setup , Mixer def. (
(maximum fourteen) defined at that point are set up in
the Menu G Mixer according to the requirements of
the particular model.
!
Notes:
The mixers defined in the menu Setup , Mixer def.
can only be used in fixed-wing model aircraft, i.e. not
in model helicopters.
In the interests of clarity, the menu G Mixer only lists
those mixers which are used in the currently selected
model, i.e. which have been assigned in the menu K
Servo , Assignment (
The mixers Combi-Sw. , Ail.Diff. and Controls
Mix are always included in the list.
, Mx1N , Mx2N , Mx3N .
14.2.). The mixers
17.2.):
The next section explains the method of setting up a
"free mixer" using the example of the mixer AILERON+ ,
which is pre-defined as standard, and is used in several
model templates:
Mode of working of the input
Mixer inputs
Allocation indicator
This example shows the method of setting the mixer
AILERON+ (
the various aileron travels), as they might
be set up for a model glider with a four-flap wing.
What does the menu show?
The third line of this menu is a "dynamic" heading for
the parameter(s) of the marked mixer input. The in-
formation actually displayed at this point varies ac-
cording to the selected mixer input:
On the left the screen shows the symbol for the
method of working of the mixer input (
The percentages indicate the significance of the
values. The possibilities are as follows:
----
No setting
trv'
Travel setting for asymmetrical inputs
trv#
Travel setting for asymmetrical inputs
trv
Travel setting for symmetrical inputs
offs
Offset
dead.
Deadband
pt 1
Curve point for control centre position
pt2
Curve point for control end-points.
The bottom five lines display the following data:
The transmitter control which generates the mixer
input
% values of the mixer inputs:
Range: -100% OFF
Status of the mixer inputs:
*
Mixer input active
-
Mixer input not active.
In the case of switched inputs:
G*
Switch G, input switched on
G-
Switch G, input switched off.
The Allocation indicator shows that the % values of
the mixer input can be allocated to one of the 3-D digi-
adjusters and - once unlocked - altered in flight (
The defintions of the pre-defined mixers can be found
in the Section ( 22.2.).
Manual
"Dynamic" heading
of the marked input
Values Mixer switch
status
14.2.2.).
100%
20.1.).
73