Main Menu ¡Setup; Menu Transmitter; Parameter Sound; Parameter Group Safety - Multiplex ROYALpro 7 Manual De Instrucciones

pro
ROYAL
REFERENCE Section
The REFERENCE SECTION is the part of the manual
where you can look up terms and find out detailed in-
formation about individual menus or parameters.
This section of the manual describes all the menus of
pro
the ROYAL . The sequence is the same as that of
the main menus when you access them directly using
the six dedicated buttons (Chapters 14. to 19.). The
description of the menus is also arranged in the order
in which they occur when you leaf through using the
3-D digi-adjusters.
All the menus are summarised in a clear manner on
the separate overview sheet supplied in the set, so
that you can quickly find functions which you do not
need to use regularly.
Main menu ¡Setup
14.
The main menu Setup is opened by pressing this but-
ton:
¡Setup
¨Exit
Transmitter ....
Mixer def. ....
Assignment ....
Training ....
User ....
The settings in these menus are "global", i.e. they ex-
tend beyond individual model memories, or apply to
the transmitter as a whole.

Menu Transmitter

14.1.
¡Transmitter
¨Exit
Sound
Safety
Check thr.
Check RF
Battery
ª Alarm
Capacity
Charge
SlfDsCharge
Display
Contrast
Trim graph
Note:
If the screen area is not sufficient to display all the
sub-menus, this is indicated by means of arrows (
or ) at the left-hand edge of the screen. In this case
you can access the start or end of the list by scrolling
up or down using the UP / DOWN buttons (
one of the two 3-D digi-adjusters.
58
14.1.
14.2.
14.3.
14.4.
14.5.
All
ON
ON
7.10V
2100mAh
275mAh
low
0
0
/

Parameter Sound

14.1.1.
The software allows you to select which events are to
be accompanied by an audible beep:
Values Meaning
Battery_ Battery alarm only
Battery alarm and trim increments
Bat+Trim
B+Tr+Tim Battery alarm, trim increments and timers
Init off All off, except power-on melody
All _ All audible signals

Parameter group Safety

14.1.2.
Parameter:
Function Warning if throttle is not at a safe setting (Idle or
(electric) motor OFF) when you switch the trans-
mitter on or change model memories
Values
ON
Default
ON
Effect Affects current model only
Parameter:
Function RF channel is displayed at power-on, and must
be confirmed before an RF signal is transmitted.
Values
ON
Default ON
Effect Affects current model only

Parameter group Battery

14.1.3.
Parameter:
Function Battery alarm threshold
Values 6.70V to 7.50V
Default
7.0V
The threshold for the battery alarm can be adjusted to
suit your own preferences and the condition of the
transmitter battery.
Tip: this setting affects the residual time, i.e. the
time between the alarm sounding and the transmitter
shutting down.
Switch the transmitter on with the aerial extended and
the RF module active (RF status LED must be flash-
ing). You do not need to operate the transmitter sticks.
Parameter:
) or
Function Capacity of the rechargeable transmitter battery
for the purposes of battery management
Values 0mAh to 4000mAh (increment 50mAh)
Default
2100mAh
Check thr.
OFF
Check RF
OFF
Alarm
(increment 0.01V)
Capacity