Angelo Po COMBIFIT CF623E Manual De Instalación, De Uso Y De Mantenimiento página 71

Set the timer or core probe temperature to the desired level by select-
ing the relative level. A pop-up will be displayed, enabling you to select
the timer (a) or core probe (b) mode. Select the desired mode, and set
the value by turning the dial M. Confirm by pressing the dial M or the
pop-up.
230°
START ALL
fig. 27
230°
S14
START ALL
fig. 28
YOU can start all the levels at once by pressing the corresponding key
S14 fig. 28.
If you use the RaCk COnTROl mode, instead, with the oven set to
STaRT, after you have set the timer or core probe temperature value,
the dedicated control will start automaticall, once you have confirmed
the value set.
Upon reaching the set core temperature or at the end of the time set
on the relative level, on display appears the writing
emits an acoustic signal. At this point you can open the oven door and
remove the pan and close the door. The relevant level will reset auto-
matically.
Note: when a level is completed and the writing
relative level, the oven does not enter the Stop mode, but continues
COMBIFIT installation, use and maintenance manual
6
5
4
a
b
3
2
1
6
5
4
0:05
55° 3
2
1
ON the left side of the screen it
is possible to set or modify the
cooking parameters (mode, tem-
perature, fan, etc.)
RaCk COnTROl can be
The
used in two different modes:
•
with oven in STOp mode
(programming);
•
with oven in STaRT mode
(cooking already started).
Setting the values of various
levels with the oven in STOp
mode; one you have pressed the
Start button (T2 page 9) the
oven will start cooking with the
values set for: cooking mode,
temperature, etc. .. set (with the
relative automatic pre-heating
cycle, if set). The operator should
then manually start the timer/
control of core temperature for
each level by pressing on the pan
icon ( ) related to the desired
level. When a level has been ac-
tivated the icon will turn red
EnD
EnD
.
and the oven
appears on the
21