Malossi MULTIVAR 2000 Manual Del Usuario página 41

» continue 5114148
Fig. 34
1 11 2
5114238
Suggestions for the setting
The variator is supplied with two different roller
sets: one of 18 gr. and one of 20 gr. in order to
change the number of revolutions of the gear
curve of your vehicle perfectly adjusting its speed
and acceleration.
• 200 cc : n° 6 rolls gr. 18
• 300 cc : n° 6 rolls gr. 20
41
5114258
Use the original roller guide cover
5
original cursors after having checked that they
(Fig. 35).
are in good condition
If they are excessively worn or damaged, change
them with original cursors.
Proceed as follows on the Malossi variator:
• The grease supplied in the kit must be put in
the internal groove both of the hub and of the
bush (Fig. 36). The seizure of the bush and
the variator collapse will be occurred If this
direction is not followed.
• Insert the hub into the movable half-pulley,
taking care not to damage the oil-seal rings.
• A plastic bush is supplied in the kit, which is
used to insert the hub into the pulley without
(Fig. 37). After the hub
damaging the oil-seal
is inserted into the bush check that there is
no grease leakage and, if necessary, carefully
remove the grease from the parts around.
• Insert the rollers in their seats.
• Use the original roller guide cover and the
original cursors. If they are excessively worn or
damaged, replace them with original cursors.
• ATTENTION: the introduction of the variator
cover inside the pulley will be lightly forced
where there is contact with the rolls. This is
intentional and it makes extremely silent the
engine at low rpm.
• Clean carefully and remove the grease from the
movable half-pulley using a suitable solvent.
6 and the