Lowara GEMK Serie Instrucciones Para La Instalación Y El Uso página 119

SELECTABLE
FUNCTION
FIELDS
Work mode
"Work mode
000/016
OUT AUX1"
Work mode
"Work mode
000/016
OUT AUX2"
9.11 INITIAL COMMISSIONING PROCEDURE (EN 12845)
This function, with the keyswitch turned to "MAN", runs a procedure which involves six automatic attempts at starting,
each lasting no less than 15 seconds, with the starting motor running and with a pause of between 10 and 15 seconds.
Use this function once only. Repeating the procedure could damage the engine.
ATTENTION
To be carried out only by qualified personnel.
Follow these instructions on how to enable the "commissioning" function:
1) Close the fuel valve of the tank delivery circuit.
Turn the panel switch to its "MAN" mode.
2)
3) Connect the batteries and power the electric panel. Press and hold the PROG / RESET / ENTER switch for more than 5
seconds to access the PASSWORD parameter. The cursor blinks.
4) Enter the PW2 password and press the PROG/RESET/ENTER key to confirm.
5) Select the function using the UP / DOWN keys and press the PROG/RESET/ENTER key to confirm.
6) Enter the parameter value using the UP / DOWN keys and press the PROG/RESET/ENTER key to confirm.
7) At the end of the procedure, the alarm, the no start message and the yellow LED under the START button are enabled.
8) Open the fuel valve of the tank delivery circuit.
9) Press the START key and start the engine manually. The yellow LED under the START key turns off.
After the test, restore pressure to the system, turn the switch to "AUT" mode, and remove the key.
DEFAULT
VALUES
000 = Disabled
001 = IN AUX 1 input alarm
002 = IN AUX 2 input alarm
003 = IN AUX 3 input alarm
004 = Heater / Battery charger alarm
005 = Remote start command
015 006 = Low engine oil pressure alarm
007 = Engine overheating alarm
008 = No power at panel alarm
009 = Low battery current alarm
010 = Engine speed alarm
015 = Pump pressure alarm
016 = Pump running
000 = Disabled
001 = IN AUX 1 input alarm
002 = IN AUX 2 input alarm
003 = IN AUX 3 input alarm
004 = Heater / Battery charger alarm
005 = Remote start command
016 006 = Low engine oil pressure alarm
007 = Engine overheating alarm
008 = No power at panel alarm
009 = Low battery current alarm
010 = Engine speed alarm
015 = Pump pressure alarm
016 = Pump running
119
NOTES