Blackmagic Design Studio Camera 4K Plus Manual De Instalación Y Funcionamiento página 45

Off Speed Frame Rate
With 'off speed recording' enabled, tap the arrows next to the 'off speed frame rate' indicator to
set your camera's sensor frame rate.
The sensor frame rate sets how many actual frames from the sensor are recorded every second
and will affect how fast or slow your video will play back at your set project frame rate.
Preferred Drive for Recording
When a USB flash disk is connected to both USB ports, use this setting to determine which
media is recorded to first. The options are 'drive 1', 'drive 2' and 'fullest drive'. Picking either
'drive 1' or 'drive 2' is a matter of personal preference and when the selected drive fills up,
your camera will then continue recording on the alternate drive. 'Fullest' can help group files
chronologically when shooting a single camera project.
You can override this setting at any time by entering the storage manager and tapping the drive
name to set it as active. It's important to note, however, that ejecting and reconnecting drives
reverts to the current 'preferred drive for recording' setting.
TIP The 'fullest' setting is based on the percentage that your recording media are
filled, rather than their sizes or the amount of data used.
Stop Rec If Drive Drops Frame
Use this setting to configure the behavior of your Blackmagic Studio Camera when dropped
frames are detected. When set to 'off,' recording continues with dropped frames. When set to
'on,' your camera stops recording if dropped frames are detected. This can prevent you wasting
time shooting unusable footage if you don't spot the dropped frame indicator.
Record Settings Page 3
The third page of the 'record' settings tab contains the following settings.
Menu Settings 45