File Naming Convention; Monitor Settings - Blackmagic Design Studio Camera 4K Plus Manual De Instalación Y Funcionamiento

File Naming Convention

Clips are always recorded to your USB-C flash disk using Blackmagic RAW.
The table below shows an example of the file naming convention:
A001_08151512_C001.mov
A001_08151512_C001.mov
A001_08151512_C001.mov
A001_08151512_C001.mov
A001_08151512_C001.mov
A001_08151512_C001.mov
A001_08151512_C001.mov
A001_08151512_C001.mov
When you are recording camera ISO files from an ATEM Mini switcher, the clips' file name will
be determined by the 'record stream' palette in ATEM Software Control. This means that the
files can be identified and linked when the ATEM project is opened in DaVinci Resolve.
For more information, please refer to the 'ATEM Mini' manual which can be downloaded from
the Blackmagic Design support center at

Monitor Settings

The 'monitor' tab lets you adjust status text, overlays, and other monitoring options for your
Blackmagic Studio Camera's LCD touchscreen, HDMI output and SDI output for Blackmagic
Studio Camera 4K Pro. These menus have two pages of options, which you can cycle through
by tapping the arrows at the edge of your camera's touchscreen, or swiping left or right.
LCD, HDMI and SDI Monitor Settings Page 1
The first page of the monitor tab contains identical settings for each output. For example, you
can set 'zebra' on for the LCD touchscreen and off for the HDMI and SDI output.
QuickTime Movie Filename
Camera Index
Reel Number
Month
Day
Hour
Minute
Clip Number
www.blackmagicdesign.com/support
Menu Settings 47