Connecting And Attaching To Your Camera - Blackmagic Design Studio Camera 4K Plus Manual De Instalación Y Funcionamiento

Connecting and Attaching to your Camera

Attaching to Tripod Handles
Each unit attaches to a tripod handle via their mounting brackets. Attach each unit to the
brackets via their rosette mounts.
To attach the demand units to their brackets, simply connect them together via their rosette
mounts and secure them by tightening the fastening knob.
1 Place the zoom demand or focus demand against their bracket's rosette mount.
2 Tighten their fastening knob so the demand units are firmly attached to their brackets.
Now that the units are attached to the brackets, you can attach the brackets to the tripod arms.
One end of each bracket contains a 'T' shaped latch that hinges into a slot and is then tightened.
1 Loosen the latch by unscrewing the latch knob in a counterclockwise motion. This will
release the 'T' shaped latch.
2 With the latch open, place the bracket onto the tripod arm and clamp the bracket shut by
closing the latch into its fastening slot. Rotate the bracket to your preferred position on the
tripod arm.
3 Tighten the latch knob to secure the bracket to the tripod arm.
Blackmagic Zoom and Focus Demands 73