Setting The Frame Rate And Resolution - Blackmagic Design Studio Camera 4K Plus Manual De Instalación Y Funcionamiento

Setting the Frame Rate and Resolution

With a lens attached and the camera turned on, the next step is to set the video format for the
HDMI or SDI output. This is the video standard and frame rate you will be sending to destination
equipment such as an ATEM switcher, a monitor, or HyperDeck disk recorder.
To set the frame rate:
1 Tap the frames per second icon marked FPS in the LCD status display. This will open
the frame rate settings using the touchscreen head up display.
2 Tap the arrows or drag the slider to set the frame rate.
3 Tap outside the setting to confirm and close the head up display.
To set the output standard:
1 Tap the menu settings icon at the top right corner of the touchscreen. This opens all
menu settings for your camera.
2 Tap the 'monitor' menu tab.
3 Tap on the right arrow to select page 2 of the monitor settings and select the HDMI or
SDI output.
4 At the bottom of the settings page, you will see the output video standard. Select
2160p for Ultra HD, or 1080p for HD.
If you are connected to an ATEM switcher via HDMI, your camera's HDMI connector will
automatically detect if the standard should be 1080p and set it accordingly.
Use page 2 of the monitor settings to set the video standard for the HDMI or
SDI output
NOTE When recording to a USB flash Disk connected to your camera's USB port, the
recording standard is always Ultra HD. This means you can still record a full resolution
Ultra HD master even if you are sending your switcher an HD feed.
Getting Started 8