Main Operating Parts; Central Unit; Working Screen; Sensors - Corghi EXACT 7000 Manual De Uso

the rear wheels (fig.19).
The units of measurement of wheel-base dif-
ference are the degree or the millimetre, only if
the track is known.
11) Side offset.
Angle formed by the line joining the ground
contact points of the front and rear wheels on
the left-hand side, or the right-hand side, and
the vehicle's axis of symmetry (fig.20).
The units of measurement of side offset are the
degree or the millimetre, only if the wheel-base
is known.
12) Axle offset.
Angle formed by the line bisecting the track
difference angle and the vehicle's thrust axis
(fig. 21).
The units of measurement of axle offset are the
degree or the millimetre, only if the wheel-base
is known.

MAIn oPERATInG PARTs

WARNING
Get to know your equipment. The best way to
prevent accidents and obtain top performance
is for all the operators who use the equipment
to know how it works. Learn the function and
layout of all the controls. Check thoroughly that
each of the equipment's controls is operating
correctly. To avoid accidents and injuries, the
equipment must be properly installed, operated
correctly and serviced as necessary.
Central unit (fig.22)
A) Monitor: shows the working screens with the
diagrams of the angles measured; the operat-
ing commands are in the bottom part.
B) Keyboard: used to select the commands
available and enter alphanumerical data.
The ENTER key recalls the command se-
lected by the arrow keys.
The ESC key returns the program to the
previous step.
C) Personal Computer: contains and executes
the vehicle wheel alignment program. Also
contains the wheel aligner control electron-
ics.
D) Remote control receiver: point the remote
control in this direction before pressing a
key.
E) Printer: allows the results of the job done to
56
be recorded on paper.
F) Remote control: wheel aligner remote control
unit.
G) Wheel aligner card, card which enables
operation of the aligner. The second slot is
used for the cards provided in the upgrade
kits.
H) Sensor connectors.
I) Power supply plug.
Working screen (fig.23)
A) Title (e.g. FRONT AXLE): indicates the pro-
cedure being used.
B) Values measured on the vehicle.
C) Databank values.
D) Graphic comparison between the values
measured and databank values.
E) Sensor level indication.
F) Representation of the angles currently being
measured.
G) HELP: command which recalls the on-line
help function.
H) Icon bar: icons you can use to move around
the program. More information about the
selected icon is provided in the feedback
bar.
I) Feedback bar: displays a help message about
the function of the selected icon.
L) Vehicle name bar: displays the name of the
vehicle selected from the databank. During
selection of the vehicle from the databank,
it shows the market selected.
M) Status bar: displays system messages.
N) Axle value difference: window containing the
value and databank reference for the differ-
ence between the right-hand and left-hand
values of the angle measured. The window
only appears when the databank contains a
reference value.
O) Operating Zone: part of the screen which
displays the working information.
sensors (Fig. 24)
A) Knob for locking the sensor to the clamp.
B) Button which releases the safety anchor
between the sensor and the clamp.
C) Connectors for connection to the central
unit or the other sensor; they can be used
for either purpose.
D) Connector for connecting the electronic
turntables.
E) Battery (for radio version sensors only).
F) Sensor control panel.
G) Sensor position: fit the sensor considering the
car direction as shown on the dataplate.
Operator's Manual EXACT 7000