Asa Network; Angle Reading Error; Aligning Cars With Large Track Differences - Corghi EXACT 7000 Manual De Uso

(4) Steering wheel centring and front
camber adjustment
Keeping the front wheels aligned and the sensors
level, adjust the steering wheel and the front
camber values.
(6) Checking and adjustment of the toe
curve
S-Point Selection
Set the steering wheel straight and fit the steer-
ing wheel clamp.
Check and adjust the toe constant,
only when the car no longer travels straight after
hitting a bump or a manhole cover, when pieces
of the suspension system have been replaced,
after an accident or when specifically required
by the manufacturer.
The toe constant checking and adjustment
sequence depends on the type of suspension
installed on the car: there are differences for
cars with STANDARD, SPORTS or ALL-TERRAIN
chassis. Follow the instructions on the screen for
the operations to be performed and the adapters
to be fitted on the checking tool.

AsA nETWoRK

To enable use of the Asa Network protocol, set up
the aligner after accessing the technical services
setup function
Then set the "Procedure" / "Asa Network Proce-
dure" option as "enabled".
When the aligner software is run, it automatically
checks the network connection, and the connec-
tion icon appears in the Windows status bar.
Operation
After starting the alignment procedure,
this system enters the screen for selection of the
working order for processing.
If the network connection is not established, a
dialogue window asks whether you wish to return
the connection,
of the vehicle from the databank without con-
78
icon,
, and
,or move on to selection
necting,
Once the order has been selected, the working
data are loaded in the form, after which the
vehicle has to be selected from the databank
in the usual way.
The alignment procedure which follows is the
usual one.
The ,
be used to print, and to save the job done if
you wish.
ends the session and sends the notifica-
tion that the order has been processed, and the
attached .XML file containing the data of the job
done to the Network Manager.

AnGLE READInG ERRoR

During the working procedures, the beams of
the CCD angle sensors may be interrupted. This
occurrence is signalled by the connection failure
symbol (Fig.46) which also indicates which beam
has been interrupted.
The angles which cannot be calculated without
the interrupted beams disappear from the adjust-
ment screens, while the other angles are correct
and can be used for adjustment.
ALIGnInG CARs
WITH LARGE TRACK
.
DIFFEREnCEs
The "High output" mode, and icons, allows
wheel alignment to be performed even on cars
with high track differences (sports cars such as
Porsche models). If this setting is not used, "Link
Error" problems serious enough to make the job
impossible may occur both during adjustment
and during the steering lock procedure.
The "High output" mode is indicated by the
,
symbol in the status bar and is maintained for
just one job.
Operator's Manual EXACT 7000
.
or icons can