Sensor Control Panel; Clamps; Remote Control; Personal Computer - Corghi EXACT 7000 Manual De Uso

sensor control panel (fig.25)
A) Sensor on/off key.
B) ROC key.
C) Special functions key.
D) Electronic levelling device LED, indicates
when the sensor is levelled.
E) Electronic levelling device LEDs, indicate
when the sensor is not levelled.
F) Sensor connection LED. When off, there
is a fault on the sensor, when it is on the
sensor is in operation but communications
with the central unit have failed, and when
it is flashing the sensor is in operation and
communicating with the central unit.
G) LED 1 on while ROC is in progress.
H) Sensor status LED. When always on, the sen-
sor is in operation; in radio versions, flashes
to warn that the battery charge is running
out.
I) LED 2 on while ROC is in progress.

Clamps

The clamps function in the same way as ordinary
wheel clamps.
Use the knobs (C fig.26) to fix the clamp to the
rim or remove it.
The release lever (A fig.26) can be used to
lower the sensor connection point to prevent
particularly low spoilers from interfering with
the measurements (fig.27).
To fix the sensor at the required height, tighten
the fixing screw (B fig.26) with the sensor in the
position of choice.
These clamps are also able to operate on cars
with wrap-around fenders (Citroen); in this case,
mount the clamps in the horizontal position.
On small-diameter rims, always perform com-
pensation with the clamps in the horizontal
position.
Remote control (Fig.22)
The Enter (N) and Esc (O) keys and the four arrows
(P) duplicate the functions of the same keys on the
keyboard and the central unit control panel.
It is powered by an ordinary 9 VDC battery.

PERsonAL CoMPUTER

Wait a few seconds to allow the monitor to switch
on and the computer to load the program.
The personal computer, and thus the entire
wheel aligner, can only be switched off using
the command provided in the wheel alignment
program.
Operator's Manual EXACT 7000
IMPORTANT
Switching off the personal computer without
using the command provided may damage the
software installation.
IMPORTANT
When the wheel aligner is switched off using
the software command, the PC, the monitor and
the printer switch to standby status. To switch
off these devices completely, use either the
relative on and off buttons, or the PC power
supply switch (switch marked C turned to 0),
or cut off the wheel aligner power supply at
the mains.
Keep the original GHOST and aligner software
CD-ROMs for future system upgrades.
IMPORTANT
The software on the CD-ROM is the property of
Corghi S.p.A. and can be used only with the per-
sonal computer supplied with the equipment.

oPERAToR InTERFACE

Commands and information for moving around
the vehicle wheel alignment program.

Icons

An icon is a key on the screen which performs a
specific action when it is selected. This function
is the same throughout the procedure.
The icon's function is identified by a graphic
symbol; a brief comment is also provided in
the feedback bar.
Locate on icons using the ←, →, ↑, ↓ keys and
select them with ↵.
If the icon selected has a submenu, it will open
vertically and the icon selected will be replaced
by . Use this icon or the ESC key to close
the menu.
identifies additional icons in the menu
for display.
Icons which are not active are plain grey in
colour.
GB
57